Advertisement
• When
mode was on, adding marks during
ADDA DIRECT
recording was not possible. This has been fixed.
• Operation stability has been improved.
Checking the firmware version
Confirm the firmware version of your DA-3000 before updating
its firmware.
1. Turn the unit's power ON.
2. Check the
(firmware version) shown below the
Ver.
"DA-3000" model name on the startup screen.
If the
firmware versions shown here are the same or
Ver.
newer than the firmware versions that you plan to update to,
then there is no need to update the firmware.
Firmware update procedures
1. Download the latest firmware from the TASCAM website
(http://tascam.com/). If the downloaded file is in ZIP format
or another compressed file type, decompress it.
2. Copy the downloaded firmware to the root directory (top
level) of the CF card.
3. While the unit is off, press and hold the PAUSE and RECORD
buttons and press the POWER switch to turn the unit on.
The screen shown below will appear.
Firmware Update
Start Update. . .
NOTE
Continue to press the buttons even after the startup screen
appears until the "Firmware Update" screen is shown.
4. Insert the CF card that contains the downloaded firmware
into the CF card slot.
The screen shown below will appear.
Firmware Update
DA-3000. 101
5. Press the MULTI JOG dial.
The screen shown below will appear.
Firmware Update
DA3000. 101
ver1.00 ->Ver1.01
Build105
Build0119
NOTE
The screen shown above is an example. The actual
appearance will differ.
6. Press the MULTI JOG dial to start the update.
2
TASCAM DA-3000
Are you sure?
DA-3000
CAUTION
• Be careful not to let the power be interrupted during the
update.
• If the power is interrupted during the update, the unit might
become unstartable.
7. When the update completes, the following screen will
appear.
Firmware Update
Update Complete!!!
Compare...
. . . . . . . . . . . 100%
8. Press the POWER switch on the unit to turn the power off.
9. Refer to "Checking the firmware version" above and confirm
that the
versions are now the latest versions.
Ver.
This completes updating.
10. Delete firmware update files from the CF card.
Release Notes
Advertisement
