Sony STR-DA1500ES Operating Instructions Manual page 19

Performing initial setup
operations
Before using the receiver for the first time,
initialize the receiver by performing the
following procedure. This procedure can also
be used to return settings you have made to
their factory defaults.
Be sure to use the buttons on the receiver for
this operation.
?/1
MEMORY/ENTER
1
Press ?/1 to turn off the
receiver.
2
Hold down ?/1 for 5 seconds.
"CLR ALL" and "PUSH ENT" appears
on the display alternately.
3
Press MEMORY/ENTER.
After "CLEARING" appears on the
display for a while, "CLEARED"
appears.
All the settings you have changed or
adjusted are reset to the initial settings.
Inserting batteries into the
remote
Insert two R6 (size-AA) batteries in the
RM-AAU056 Remote Commander.
Observe the correct polarity when installing
batteries.
Notes
• Do not leave the remote in an extremely hot or
humid place.
• Do not use a new battery with old ones.
• Do not mix manganese batteries and other kinds of
batteries.
• Do not expose the remote sensor to direct sunlight
or lighting apparatuses. Doing so may cause a
malfunction.
• If you do not intend to use the remote for an
extended period of time, remove the batteries to
avoid possible damage from battery leakage and
corrosion.
• When you replace the batteries, the remote buttons
may be reset to their factory settings. If this
happens, reassign the buttons again (page 40).
• When the remote no longer operates the receiver,
replace all the batteries with new ones.
GB
19