Alignment Settings - Panasonic TX-29PX20D Service Manual

ALIGNMENT SETTINGS

(The figures below are nominal and used for representative purposes only.)
1. Set the Bass to maximum position, set the Treble to minimum position, set the Volume to minimum then press the
down button (-/v) on the customer controls at the front of the TV and at the same time press the INDEX button on the
remote control, this will place the TV into the Service Mode 1.
2. Press the RED / GREEN buttons to step up / down through the functions.
3. Press the YELLOW / BLUE buttons to alter the function values.
4. Press the STR button after each adjustment has been made to store the required values.
5. To exit the Service Mode, press the "N" button.
Alignment Function
Horizontal Position
Vertical Position
Horizontal Amplitude
Vert. Amplitude
EW-amplitude
Lower Corner
Trapezium-comp
Upper Corner
Vertical Symmetry
Vertical Linearity
Angle
Bow
DVCO
Highlight
Lowlight
Sub-Brightness
Setting indication
Note: All setting values are approximate
H-Pos
31
V-Pos
-44
H-Amp
-4
V-Amp
–11
EW-Amp 1
- 35
Lower Corner
4
Trapez 1
-4
Upper Corner
1
V-Sym
-13
V-Lin
34
Angle
0
Bow
1
DVCO
-1
High 0373 0343 0350
Low 0161 0154 0160
Sub-Brightness
-13
6
Settings / Special features
Optimum setting.
Optimum setting.
Optimum setting.
Optimum setting.
Optimum setting.
Optimum setting.
Optimum setting.
Optimum setting.
Optimum setting.
Optimum setting.
Optimum setting.
Optimum setting.
Receive a PAL Colour Bar Pattern. For
DVCO alignment press "Blue" button, wait
until the colours are changing slowly and
press "STR".
Optimum setting.
Optimum setting.