Table of Contents
Advertisement
Promatrix 6000 Router
HIGH
F
F
Table 7.1: CAN addresses
7.2
Displaying the CAN baud rate
To display the CAN baud rate, press the Recessed button and keep the button pressed down
for at least one second. Three front panel indicator lights then display the set baud rate for
two seconds, afterwards all indicators light up ("LED test"). Please refer to the following table
for details.
Baud rate (in kbit/s)
10
20
62.5
125
250
500
Table 7.2: Displaying the CAN baud rate via indicator lights on the front panel
7.3
Configuring the CAN baud rate
The CAN baud rate can be configured using a UCC1 USB-CAN CONVERTER or directly on the
front of the device.
Changing the CAN baud rate
Notice!
The CAN baud rate can only be changed if the CAN address is set to 00.
To change the CAN baud rate, perform the following steps:
1.
2.
3.
4.
5.
LOW
0 to A
B to F
Zone status indicator
light of zone 23
Off
Off
Off
On
On
On
Press the Recessed button and keep the button pressed down for at least one second.
The CAN baud rate is indicated for two seconds, please refer to the section entitled
"Displaying the CAN baud rate" for more information.
As soon as the CAN baud rate is displayed, release the Recessed button. Please note that
if the button is pressed for more than 3 seconds, the device will be reset to factory
settings.
Briefly press the Recessed button to switch to the next-higher CAN baud rate. The LEDs
indicate the new setting.
Repeat step 3 until the desired baud rate has been set. (Example: To change the baud
rate from 62.5 kbit/s to 20 kbit/s, press the Recessed button exactly five times, i.e. 62.5 >
125 > 250 > 500 > 10 > 20).
The new CAN baud rate is applied two seconds after the last time that the Recessed
button is pressed.
Address
240 to 250
Reserved
Zone status indicator
light of zone 24
Off
On
On
Off
Off
On
Operation manual
Configuration | en
25
Network indicator
light
On
Off
On
Off
On
Off
18-Jun-2015 | 03 | F01U306895
Advertisement
Table of Contents
