Safety Information - Sony Bravia KDL-40W3000 Operating Instructions Manual

Safety information

Installation/Set-up
Install and use the TV set in accordance with the
instructions below in order to avoid any risk of fire,
electrical shock or damage and/or injuries.
Installation
• The TV set should be installed near an easily accessible
mains socket.
• Place the TV set on a stable, level surface.
• Only qualified service personnel should carry out wall
installations.
• For safety reasons, it is strongly recommended that you
use Sony accessories, including:
KDL-52W3000/46W3000/40W3000:
– Wall-mount bracket SU-WL500
KDL-52W3000/46W3000/40W3000:
– Floor stand SU-FL62
KDL-46W3000/40W3000:
– TV stand SU-FL300M
Transporting
• Before transporting the
TV set, disconnect all
cables.
• Two or three people are
needed to transport a large
TV set.
• When transporting the TV
set by hand, hold it as
shown on the right. Do not
put stress on the LCD
panel.
• When lifting or moving
the TV set, hold it firmly
from the bottom.
• When transporting the TV
set, do not subject it to
jolts or excessive
vibration.
• When transporting the TV
set for repairs or when moving, pack it using the original
carton and packing material.
Ventilation
• Never cover the ventilation holes or insert anything in the
cabinet.
• Leave space around the TV set as shown below.
• It is strongly recommended that you use a Sony wall-
mount bracket in order to provide adequate air-circulation.
Be sure to hold the
bottom of the panel, not
the front part.
Installed on the wall
10 cm
Leave at least this space around the set.
Installed with stand
30 cm
10 cm
Leave at least this space around the set.
• To ensure proper ventilation and prevent the collection of
dirt or dust:
– Do not lay the TV set flat, install upside down,
backwards, or sideways.
– Do not place the TV set on a shelf, rug, bed or in a
closet.
– Do not cover the TV set with a cloth, such as curtains,
or items such as newspapers, etc.
– Do not install the TV set as shown below.
Air circulation is blocked.
Wall
Mains lead
Handle the mains lead and socket as follows in order
to avoid any risk of fire, electrical shock or damage
and/or injuries:
– Connect the TV set using a three-wire grounding type
mains plug to a mains socket with a protective earthing
connection.
– Use only Sony mains leads, not those of other brands.
– Insert the plug fully into the mains socket.
– Operate the TV set on a 220–240 V AC supply only.
– When wiring cables, be sure to unplug the mains lead
for your safety and take care not to catch your feet on
the cables.
– Disconnect the mains lead from the mains socket before
working on or moving the TV set.
– Keep the mains lead away from heat sources.
30 cm
10 cm
10 cm
10 cm 6 cm
Wall
Continued
9
GB