Vehicle Identification Plates - Mercedes-Benz B-Class 2011 Owner's Manual

Vehicle identification plates

310
Use the Technical Specification
20
ISO/TS 21609
frequency) transmitters. Legal provisions for
fittings must be observed.
If your vehicle has fittings for two-way radio
equipment, use the power supply or aerial
connections intended for use with the basic
wiring. Be sure to observe the manufacturer's
additional instructions when installing.
Deviations with respect to wavebands, maxi-
mum transmission outputs or aerial positions
must be approved by Mercedes-Benz.
The maximum transmission output (PEAK) at
the base of the aerial must not exceed the
following values:
Waveband
Short wave (f < 54 MHz)
4 m waveband
2 m waveband
Trunked radio/Tetra
70 cm waveband
GSM/DCS/PCS
850/900/1800/1900
UMTS/LTE
The following can be used in the vehicle with-
out restrictions:
RF transmitters with a maximum transmis-
R
sion output of up to 100 mW
mobile phones (GSM/DCS/PCS/UMTS/
R
LTE)
There is no restriction for aerial positions in
the outer area of the vehicle for the following
wavebands:
trunked radio/Tetra
R
70 cm waveband
R
ISO/TS 21609 – Technical Specification for Road Vehicles – EMC guidelines for installation of aftermarket
20
radio frequency transmitting equipment.
when retrofitting RF (radio
Maximum
transmission
output
100 W
30 W
50 W
35 W
35 W
10 W
10 W
GSM/DCS/PCS
R
UMTS/LTE
R
Vehicle identification plates
Vehicle identification plate with vehi-
cle identification number (VIN) and
paint code number
Open the front right-hand door.
X
You will see vehicle identification plate :.
Example: vehicle identification plate
Vehicle identification plate
:
Vehicle manufacturer (Daimler AG)
;
EU general operating permit number (only
=
for certain countries)
Vehicle identification number (VIN)
?
Maximum permissible gross weight (kg)
A
Maximum permissible gross weight of
B
vehicle/trailer combination (kg)
Maximum permissible front axle load (kg)
C