Table of Contents
Advertisement
" Setup
18
To connect an Ethernet Hub to the KX-HGW200:
If you are not currently using an Ethernet hub to network more than one
computer, please skip this page.
Note:
If using an Ethernet connection, an Ethernet card and software have
to be installed properly on the computer first.
Make sure the computers and other devices connected to the Ethernet
1
Hub are turned off.
2
Set the HUB/PC switch of the KX-HGW200 to HUB.
HUB/PC switch
To RJ-45 jack
on the cable/
xDSL modem
Connect the category 5 straight cable to
3
TO COMPUTER/ETHERNET HUB port of the KX-HGW200.
TO COMPUTER/
ETHERNET HUB port
4
Connect the other end of the category 5 straight cable to the LAN port
of the Ethernet Hub.
Category 5
straight cable
Note:
Do not connect the category 5 straight cable to the UPLINK port of the
Ethernet Hub.
LAN port
Ethernet Hub
Advertisement
Table of Contents
