Installing And Removing Memory Expansion; Removing Memory Modules - Fujitsu LIFEBOOK U7310 Operating Manual

Installing and removing memory expansion

System expansion System expansion Removing memory Mainmemory Memorymodule
If you are asked by the Hotline/Service Desk to remove and install the memory
expansion yourself, proceed as follows:
Please observe the safety information in chapter
When installing/removing memory modules, the battery must be removed from
the notebook and the notebook must not be connected to the power supply,
see "Preparing to remove components", Page
Only use memory expansion modules that have been approved for your
notebook (see
Never use force when installing or removing a memory extension.
Make sure that foreign objects do not fall into the memory extension compartment.
You must open the service compartment to remove or install a memory module. On some devices,
opening the compartment may expose other components. These components should be removed
and replaced only by authorised specialists. Therefore, be sure to observe the following:
Individual components can become very hot during operation. Therefore, we
recommend that you wait one hour after switching off the notebook before removing
or installing memory modules. Otherwise, there is a risk of suffering burns!
As some components are exposed that are sensitive to static electricity, please take
note of chapter

Removing memory modules

3
1
Fujitsu
Removing and installing components during servicing
"Technical data", Page
"Notes on installing and removing boards and components", Page
2
1
"Important notes", Page
63.
84).
► Carefully push the two mounting
clips outwards (1).
Memory module Memory expansion
The memory module snaps upwards (2).
► Pull the memory module out of its slot
in the direction of the arrow (3).
12.
62.
65