Troubleshooting Guide; Maintenance; Specifi Cations - Panasonic SC-SP100 Operating Instructions Manual

Troubleshooting guide

Before requesting service, make the following checks. If you are in
doubt about some of the check points, or if the solutions indicated
in the following guide do not solve the problem, refer to "Customer
Services Directory (United States and Puerto Rico)" on page 13 if you
reside in the U.S.A. or Puerto Rico, or refer to "Product information" on
page 11 if you reside in Canada.
No power • Ensure the AC power supply cord is
No sound • Adjust the volume.
• Check if mute function is enabled.
• Update your iPod or iPhone with the latest
• The iPod or iPhone was incorrectly inserted
Remote control is
• Replace the battery.
not functioning • Ensure the iPod or iPhone is seated properly
Distorted sound • Reduce the volume.
• Set the "EQ" setting of the iPod to "Off" or
iPod or iPhone • Check the connections. (\ page 7)
does not charge
Unable to use PC • Turn the main unit on.
synchronization • Check PC and iPod or iPhone connections.

Maintenance

To clean this unit, wipe with a soft, dry cloth.
• Never use alcohol, paint thinner or benzine to clean this unit.
• Before using chemically treated cloth, read the instructions that came
10 with the cloth carefully.
connected properly.
software.
into the dock. Turn off the iPod or iPhone,
remove it from the dock connector. Reinsert
it and turn it on again.
into the unit.
"Flat".
(\ page 7, 9)
Specifi cations
AMPLIFIER SECTION
RMS output power stereo mode
Front Ch (both channels driven)
Subwoofer Ch 10 W per channel (6 Ω), 100 Hz, 10% THD
Total RMS stereo mode power
TERMINALS SECTION
Music port (rear)
Sensitivity
Terminal
SPEAKER SECTION
Front speakers
Speaker unit(s)
Full range
Input power (IEC)
Subwoofer
Speaker unit(s)
Woofer
Passive radiator (x2)
Input power (IEC)
GENERAL
Power supply
Power consumption
AC adapter (switching power supply)
AC adapter power consumption
Dimensions (WxHxD)
Mass [Weight]
Operating temperature range
Operating humidity range
Power consumption in standby mode:
Note:
1) Specifi cations are subject to change without notice.
Mass and dimensions are approximate.
2) Total harmonic distortion is measured by the digital spectrum
analyser.
5 W per channel (6 Ω), 1 kHz, 10% THD
350 mV, 13.2 kΩ
Stereo, 3.5 mm (
Impedance: 6 Ω
4 cm (1 5 / ") cone type
8
5 W (Max)
Impedance: 6 Ω
6.5 cm (2 1 / ") cone type
2
6.5 cm (2
10 W (Max)
DC 12 V (DC IN terminal)
16 W (unit only)
AC 100 to 240 V, 50/60 Hz
175 mm x 138.8 mm x 178.5 mm
(6 7 / " x 5 15 /
8 32
0.85 kg (1.87 lbs)
0°C to +40°C (+32°F to +104°F)
20% to 80% RH (no condensation)
0.7 W (approximate)
20 W
1 / ") jack
8
1 / ")
2
36 W
" x 7 1 / ")
6