Solving Interactive Features Problems; Solutions When "Error Occurred In The Easy Interactive Function" Message; Appears; Solutions When The Interactive Pens Do Not Work - Epson EB-735Fi User Manual

Solving Interactive Features Problems

Check the solutions in these sections if you have problems using the
interactive features (EB‑735Fi/EB‑725Wi).
g g Related Links
• "Solutions When "Error Occurred in the Easy Interactive Function" Message

Appears"

p.277
• "Solutions When the Interactive Pens do not Work"
• "Solutions When You Cannot Operate a Computer from the Projected
Screen" p.278
• "Solutions When the Interactive Pen Position is not Accurate"
• "Solutions When the Interactive Pens are Slow or Difficult to Use"
• "Solutions When the Interactive Touch Operation does not Work"
• "Solutions for Problems with Capturing, Printing, Saving, or Scanning"
p.279
• "Solutions When the Time is Incorrect in Whiteboard Settings"
• "Solutions When Whiteboard Mode does not Start"
Solutions When "Error Occurred in the Easy
Interactive Function" Message Appears
If the "Error occurred in the Easy Interactive Function" message appears,
contact Epson for help.

Solutions When the Interactive Pens do not Work

If the interactive pens do not work, try the following solutions:
• Make sure you are not covering the black section near the tip of the pen.
• Try holding the pen at a different angle so that your hand is not blocking
the signal.
• Press the button on the side of the pen to check the remaining battery
power. If the battery indicator does not turn on, replace the battery.
• Make sure the pen tip is securely attached to the pen.
• If the pen tip is worn out or damaged, you may need to replace it.
p.277
p.278
p.278
p.278
p.279
p.280
• Make sure nothing is blocking the signal between the pen and the
interactive pen receiver on the projector.
• Make sure the cable cover is in place to keep cables from blocking the
signal.
• Dim the room lights and turn off any fluorescent lights. Make sure the
projection surface and pen receiver are not in direct sunlight or other
sources of bright lighting.
• Make sure the interactive pen receiver on the projector is clean and free
from dust.
• Make sure there is no interference from infrared remote controls, mice, or
infrared microphones.
• Make sure you perform pen calibration when using the interactive pen for
the first time so that the projector recognizes the position of the pen
correctly. See your projector's Installation Guide for details.
• When using multiple projectors and interactive pens in the same room,
interference may cause pen operations to become unstable. Connect the
projectors using the optional remote control cable set and set the Sync of
Projectors setting to Wired.
Pen/Touch > Installation of Projectors > Sync of Projectors
s
If you do not have a remote control cable set, set the Infrared Intensity
setting to Strong in the projector's Pen/Touch menu.
Pen/Touch > Installation of Projectors > Infrared Intensity
s
• Try replacing the soft pen tip with the hard pen tip. Doing so may improve
pen operations because some of the projector models do not support the
soft pen tip.
g g Related Links
• "Replacing the Interactive Pen Tip"
• "Using the Interactive Pens" p.96
• "Installing Batteries in the Pens" p.45
• "Getting the Latest Version of the Documents"
• "Projector Pen And Touch Setup Settings - Pen/Touch Menu"
p.259
p.10
p.237
277