Basic Setup; Using The Local User Interface; Identifying Device Revision; Language Selection - Emerson Fisher 4320 Instruction Manual

Instruction Manual
D103621X012

Basic Setup

Using the Local User Interface

CAUTION
When accessing the pushbuttons or terminals proper means of electrostatic discharge protection is required. Failure to
provide appropriate protection can cause the device to malfunction.
The primary function of the local user interface is for calibration. However, information for checking the status of the
device, as well as the connected equipment or valve, is also available through the local user interface.
Note
The valve must move from open to closed, or vice versa, in order for the wireless position monitor to be calibrated. Attempting to
calibrate the device without moving the valve will result in the action being discarded. The operation of the device will be
unchanged.
The calibration function of the local user interface can be locked out from the HART master for security purposes.
The two buttons on the LCD display (see figure 21) are used to activate the display when the LCD is in the sleep state
(blank or off). The buttons can be pressed alone or simultaneously. The Emerson logo will display when the LCD is
activated from a HART "squawk" command. Refer to Locate on page 55 for additional information.
When navigating the interface the left button is generally used to "SELECT" or take an action, the right button is used
to go to the "NEXT" option. Refer to figure 21 for the local interface flow chart.

Identifying Device Revision

To identify the device revision when the device is in the sleep state, press the right button.

Language Selection

Pressing both buttons activates the language selection menu. Press the right button "NEXT" to scroll to the desired
language, then press the left button to "SELECT" the language.
4320 Position Monitor
October 2012
25