Installing Your Attachments - Oster FPSTSMPL2 Instruction Manual

InStallInG yoUr attaCHMentS

to attach BoWL (Figure A):
1. Rotate Control Knob to off position "O" to turn unit off.
2. Unplug Stand Mixer.
3. Press Tilt Release button and tilt mixer head back.
4. Place bowl on bowl locking plate.
5. Turn bowl gently in a clockwise direction so that bowl
handles are perpendicular to base.
6. Plug into a grounded 3 prong outlet.
to reMove BoWL (Figure B):
1. Rotate Control Knob to off position "O" to turn unit off.
2. Unplug Stand Mixer.
3. Press Tilt Release button and tilt mixer head back.
4. Turn bowl counterclockwise and lift off locking plate.
to instaLL attachMents (Figure C):
1. Rotate Control Knob to off position "O" to turn unit off.
2. Unplug Stand Mixer.
3. Press Tilt Release button and tilt mixer head back.
4. Align the key positions of the beater shaft and attachment,
push upward.
5. Twist counterclockwise so that pin aligns with attachment
notch and clicks into position.
6. Plug into a grounded 3 prong outlet.
note: Align the key positions of the beater shaft
and attachment.
to reMove attachMents (Figure D):
1. Rotate Control Knob to OFF position to turn unit off.
2. Unplug Stand Mixer.
3. Tilt mixer head back.
4. Press attachment upward as far as possible and turn
clockwise.
5. Pull attachment from beater shaft.
note: It is recommended to scrape food off attachment
with a spatula/scraper before removing.
e ng li s h 6
Figure A
Figure B
Figure C
Figure D