Connection Instructions; Water Supply Connections - AEG FAVORIT 54710 Operating Instructions Manual

Connection instructions

Any electrical work required to install this appliance should be carried out by a
qualified electrician or competent person.
Any plumbing work required to install this appliance should be carried out by a
qualified plumber or competent person.
Remove all packaging before positioning the machine.
If possible, position the machine next to a water tap and a drain.

Water supply connections

This dishwasher may be fed with either hot (max. 50°) or cold water.
Nevertheless we advise you a cold water supply.
A hot water supply is not always efficient with very soiled crockery as it shortens the
washing programmes a lot.
The water pressure must be within the limits given in the technical specifications.
Your local Water Authority will advise you on the average mains pressure in your
area.
The dishwasher features fill and drain hoses which can be turned either to the left or
to the right to suit the installation. The locknut must be correctly fitted to avoid
water leaks.
Avoid bends or kinks in the hose which could prevent or slow down the water supply.
If the machine is connected to new pipes or pipes which have not been used for a
long time, you should run the water for a few minutes before connecting the inlet
hose. This will prevent deposits of sand or rust clogging the inlet hose filter.
Do not use, for connection, old hoses which have been used in another
appliance.
Your dishwasher has been built in accordance with the valid regulations governing
water-consuming appliances and is equipped with safety devices which prevent used
water from flowing back into the drinking water mains.
35