Philips 5505 Series Quick Start Manual page 13

•
Depending on the environment, the temperature of this unit may
increase slightly. This is not a malfunction.
•
When installing this unit in a temperate environment, avoid a place with
rapid temperature changes.
– Operating temperature: 41 °F (5 °C) to 104 °F (40 °C)
•
This unit should not be used in a tropical environment as it has not been
evaluated under such conditions.
•
No objects should be placed directly on or under this unit, especially
lighted candles or other flaming objects.
•
Depending on your external devices, noise or disturbance of the picture
and / or sound may be generated if the unit is placed too close to them.
In this case, please ensure enough space between the external devices
and the unit.
•
Do not insert the AC power cord into the power socket outlet before all
the connections are made.
•
Ensure that you always have easy access to the AC power cord and
outlet to disconnect the TV from the AC outlet.
•
Before you move the TV, disconnect attached cables to prevent damage
to connectors, especially the TV tuner.
•
Be sure to unplug the AC power plug from the AC outlet before moving
or carrying the unit.
•
When moving the TV and then setting it down, please be careful not to
pinch the AC power cord under the unit.
Regulatory notices
WARNING: To prevent injury, this apparatus must be securely attached to
the furniture / wall in accordance with the instructions.
Tipping, shaking or rocking the unit may cause injury / death.
WARNING: Never place a TV in an unstable location. A TV may fall, causing
serious personal injury or death. Many injuries, particularly to
children, can be avoided by taking simple precautions such as:
– Using cabinets or stands recommended by the manufacturer
of the TV.
– Only using furniture that can safely support the TV.
– Ensuring the TV is not overhanging the edge of the
supporting furniture.
– Not placing the TV on tall furniture (for example, cupboards
or bookcases) without anchoring both the furniture and the
TV to a suitable support.
– Not placing the TV on cloth or other materials that may be
located between the TV and supporting furniture.
– Educating the children about the dangers of climbing on
furniture to reach the TV or its controls.
If your existing TV is being retained and relocated, the same
considerations as above should be applied.
Do not place the unit on the furniture that is capable of being tilted by a
child and an adult leaning, pulling, standing or climbing on it. A falling unit
can cause serious injury or even death. In order to avoid interruption of
ventilation, this unit should not be placed in built-in equipment such as a
book cabinet, rack, etc., and the vents of this unit should not be covered
with anything such as a tablecloth, curtain, newspaper, etc. Make sure
that there is enough ventilation space (4 " / 10 cm or more) around this
unit.
Press to turn the unit on and go into standby mode. To completely
turn off the unit, you must unplug the AC power plug from the AC power
outlet. Disconnect the AC power plug to shut the unit off when trouble is
found or not in use. The AC plug shall remain readily available.
AC power plug
Never use a gas duster on this TV.
The gas trapped inside of this unit may cause ignition and explosion.
Environmental care
The packaging of this product is intended to be recycled.
Contact your local authorities for information about how to recycle the
packaging.
For product recycling information, please visit - www.recycle.philips.com
End of life directives
Philips pays a lot of attention to produce environmental-friendly products
in green focal areas. Your new TV contains materials which can be
recycled and reused. At the end of its life, specialized companies can
dismantle the discarded TV to concentrate the reusable materials and to
minimize the amount of materials to be disposed of. Please ensure you
dispose of your old TV according to local regulations.
# Batteries usage
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace
only with the same or equivalent type.
WARNING: Batteries (battery pack or battery installed) should not be
exposed to excessive heat such as sunshine, fire or the like.
•
Do not mix old and new batteries.
•
Do not mix alkaline, standard (carbon-zinc) or rechargeable (ni-cad,
ni-mh, Li-ion, etc.) batteries.
Disposal of used batteries
The batteries supplied do not contain the heavy metals mercury and
cadmium, however in certain localities, disposing batteries with household
waste is not permitted. Please ensure you dispose of batteries according
to local regulations.
Preparing to move / ship the unit
Please pack the unit properly by following the
diagram on the carton.
•
To avoid damage to the screen, do not pack the
stand on the same side as the TV screen, refer to
the illustration.
Federal communications commission notice
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced radio or television technician
for help.
This device complies with part 15 of the FCC rules. Operation is subject
to the following two conditions: (1)This device may not cause harmful
interference, and (2)This device must accept interference received,
including interference that may cause undesired operation.
Declaration of conformity
Trade name: PHILIPS
Responsible party: Funai Corporation, Inc.
Model: 32PFL5505/F7
Address:
12489 Lakeland Road, Santa Fe Springs, CA 90670,
USA
Telephone number : 1 866 309 5962
Modifications
This apparatus may generate or use radio frequency energy. Changes or
modifications to this apparatus may cause harmful interference.
Any modifications to the apparatus must be approved by Funai
Corporation.
The user could lose the authority to operate this apparatus if an
unauthorized change or modification is made.
Cables
Connections to this device must be made with shielded cables with
metallic RFI / EMI connector hoods to maintain compliance with FCC
rules and regulations.
Canadian notice
CAN ICES-3 (B)/NMB-3 (B) Analog and digital television receiving
apparatus, Canada BETS-7 / NTMR-7.
The following FCC/IC RSS applies to the wireless LAN adapter included
in this product.
FCC caution: Any changes or modifications not expressly approved by
the party responsible for compliance could void the user's authority to
operate this equipment.
This transmitter must not be co-located or operated in conjunction with any
other antenna or transmitter.
FCC/IC RF Exposure Compliance
This equipment complies with FCC/IC radiation exposure limits set forth
for an uncontrolled environment and meets the FCC radio frequency
(RF) Exposure Guidelines and RSS-102 of the IC radio frequency (RF)
Exposure rules. This equipment should be installed and operated
keeping the radiator at least 20 cm or more away from your body.
This device complies with Part 15 of FCC Rules and Industry Canada
licence-exempt RSS standard(s). Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may
cause undesired operation of this device.
5150-5250 MHz band is restricted to indoor operations only.
High-power radars are allocated as primary users (i.e.priority users) of the
bands 5250-5350 MHz and 5650-5850 MHz and that these radars could
cause interference and/or damage to LE-LAN devices.
Compliance with FCC requirement 15.407(c) and IC requirement
RSS-210A9.4.4
Data transmission is always initiated by software, which is the passed down
through the MAC, through the digital and analog baseband, and finally to
the RF chip. Several special packets are initiated by the MAC. These are the
only ways the digital baseband portion will turn on the RF transmitter, which
it then turns off at the end of the packet. Therefore, the transmitter will be
on only while one of the aforementioned packets is being transmitted. In
other words, this device automatically discontinue transmission in case of
either absence of information to transmit or operational failure.