Battery Installation; Selecting Channels - Graco PD211739 Owner's Manual

Parent Unit
• Remove the battery door cover on the
Parent Unit with a key or flat blade screw
driver.
• Place 3-AAA (1.5V-LR03) batteries into
the battery compartment. Note the
proper orientation of the batteries.
• Do not mix old and new batteries.
• Do not mix alkaline, standard
(carbon zinc), or rechargeable
(ni-cadmium, etc) batteries.
• Place the battery door back on the unit.
• Please remove a dead battery promptly.
A dead battery left in the unit may leak,
damaging your unit.
• Do not attempt to recharge a
non-rechargeable battery.
• A rechargeable battery CANNOT be recharged by plugging the AC adapter into the
Parent Unit.
• Remove the batteries from the unit if it is no longer being used or will be stored for an
extended period of time.
• The Parent Unit uses 3-AAA (1.5V-LR03) batteries or standard 120 volt AC household
current. The Nursery Unit uses standard 120 volt AC household current.
• To use AC adapters, plug the connector on the cord into the AC adapter jack on the side
of the Parent Unit and the back of the Nursery Unit. Then plug adapter into a standard
wall outlet.
• Use ONLY the Graco adapters included with the unit. Do not use these adapters with
other equipment under any circumstances.
• If units do not work, check that AC adapters are plugged into working outlets.
• In case you are experiencing some interference, the
channel on the Nursery Unit can be changed by sliding
the "ch" button on the side of the unit to either
channel A or B ("X" or "Y").
• The channel on the Parent Unit can be changed by
sliding the "ch" button on the side of the unit to either
channel A or B ("X" or "Y").
NOTE: Both units must be on the same channel.

Battery Installation

Using AC Adapters

Selecting Channels

3
Batteries should be disposed of
properly by recycling.
-
+
-
+
-
+
A
B
A
B