SUPPLIED ACCESSORIES
Check the accessories before installations.
•
Operating Instruction book
(TQBC0256)
•
Warranty Card
•
Service Center List
Remote control battery installation
Requires two AAA batteries.
1. Turn the transmitter face down.
Remove top cover by pressing
down on marking and sliding
cover off in the direction indicated.
Helpful Hint:
For frequent remote control
users, replace old battery with
Alkaline batteries for longer life.
•
Remote Control Transmitter
(TNQE262)
OPEN
CLOSE DISPALY
POWER
ANGLE
ENTER
TV
MENU
RETURN
SKIP
SLOW/SEARCH
STOP
PAUSE
PLAY
ASPECT TV/VIDEO
MUTE
CH
VOL
SLEEP
SURROUND
CANCEL
REPEAT MODE A-B REPEAT PLAY MODE
R-TUNE
•
AC Adaptor & AC Cord
AC Adaptor: (N0JEHK000001)
AC Cord: (K2CA2EA00005)
2. Install the batteries as shown in
the battery compartment. (Polarity
+ or – must match the markings in
the compartment).
Two AAA size
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will
damage the remote control transmitter.
Observe the following precautions:
1. Batteries should always be replaced as a pair. Always use new
batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: "Zinc Carbon" with "Alkaline").
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when remote control acts
sporadically or stops operating this unit.
Installation
•
Battery for the Remote Control
Transmitter
(2
AAA size)
3. Replace the cover and slide in
reverse until the lock snaps.
7