Canon Creative Park JAGUAR XKR Assembly Instructions Manual

JAGUAR XKR : Assembly Instructions
(Front view)
View of compleate model
JAGUAR XKR
The Jaguar XKR brings the Jaguar Sports Car tradition that began with the XK 120, into the modern era. The sleek
curves of the Jaguar XKR are reminiscent of the Jaguar E-type, a timeless classic from the 1960s, and give the car
an exemplary "British" air. Features inside include new twin air intakes, and the Super Charged 4.2 liter V8 engine
employs a variable inlet camshaft timing system that extracts a peak torque of 560Nm and a maximum power output
of 420hp. The Jaguar XKR accelerates from 0 to 100km/h in just 5.2 seconds. The super charger means that high
levels of power and torque are achieved at any engine speed.
This papercraft is about one eighteen the size of a real Jaguar XKR.
*This model was designed for Papercraft and may differ from the original in some respects.
Tools
Scissors Ruler Glue An instrument with a pointed tip (eg. a stencil pen or bodkin)
A cylindrical rod (a knitting needle or pencil)
Something to color the edges of the paper after cutting (a marker or some paint)
A craft mat etc
Notation Key
Mountain fold
Glue, scissors and other tools may
be dangerous to young children so
Valley fold
be sure to keep them out of the
Scissors line
reach of young children.
Be careful not to cut your fingers
Glue tab
when using scissors.
Cut in line
Instructions
1 . Use scissors to cut out all the pieces carefully.
Tape Tweezers Toothpicks 2 . To add curves, take the part in your hand and use a cylindrical rod to work a curve into it.
3 . Check the instructional diagrams for mountain folds and valley folds, and use something pointed to score along the fold lines. It is
important to make each fold clean.
4 . Before gluing, look at the instructional diagrams and photos and put the pieces together roughly to see how the finished product should
look. This will also give you an idea of where to add curves.
If the white edges of the parts you have cut stand out, color them with a marker pen or paint in the same color as the part before gluing.
This will result in a cleaner finish.
5 . After placing the pieces together roughly, add glue to the glue tabs (marked
Pour some glue onto a piece of paper, and use a toothpick to spread a thin layer on the glue tabs. This will ensure a clean finish.
Be sure to attach the parts in order as shown by the numbers in squares. Take your time and glue each one carefully.
View of compleate model
Assembly Instructions ; Seven A4 sheets
No. of Parts ; 49
*Bulid the model by carefully reading the Assembly Instractions, in the parts sheet page order.
- 1 -
(Side view)
View of compleate model
) and assemble the model.
(Back view)