Table of Contents
Advertisement
Before washing/drying for the
first time
The washer dryer was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
Fluff Clean
40°C
l
time
laundry.
without
Note:
The washer dryer must have been
■
installed and connected properly.
Installation and connection
~ Page 37
Never switch on a damaged washer
■
dryer.
Inform your customer service
~ Page 35
Plug into the mains.
1.
Turn the tap on.
2.
Switch on the appliance.
3.
Close the door. Do not load any
4.
laundry.
Select the
5.
Fluff Clean
programme.
Open the detergent drawer.
6.
Pour approx. 1 litre of water into
7.
dispenser
.
II
Add standard detergent to
8.
dispenser
according
II
to manufacturer's instructions for
light soiling.
To prevent frothing, use only
Note:
half the recommended amount
of detergent. Do not use any
woollens or mild detergents.
Close the detergent drawer.
9.
Select
A (Start/
10.
When the programme ends, switch
11.
off the appliance.
Your washer dryer is now ready for use.
programme the first
40°C
l
Reload
.
)
Installation and connection
Transportation
Preparatory work
Turn off the tap.
1.
Release the water pressure in the
2.
supply hose.
Filter in the water inlet hose blocked
~ Page 29
Drain any residual washing water.
3.
Drain pump blocked ~ Page 29
Disconnect the washer dryer from
4.
the power supply.
Remove the hoses.
5.
Installing transportation protection
devices:
Remove the covers and keep in a
1.
safe place.
If required, use a screwdriver.
Insert all 4 sleeves.
2.
Clamp the mains cable on the
holders. Insert and tighten the bolts.
Before switching on the appliance:
Notes
remove the transportation
Always
■
protection devices!
To prevent unused detergent from
■
flowing into the outlet during the next
wash: Pour 1 litre of water into
dispenser
and start the
II
programme.
Empty
[
en
0 or
Spin
43
Advertisement
Table of Contents
