Personal Computers That Can Be Connceted - Fujitsu Plasmavision PDS4203 User Manual

PERSONAL COMPUTERS THAT CAN BE CONNECTED
The Plasmavision is set at the factory with adjustment values for 11 types of signals. (See the table below.) When any of
these signals is input, it is automatically discriminated. For these signals, the desired screen can be adjusted according
to the instructions on adjusting the screen.
The Plasmavision can also store settings for five types of signals in addition to those set at the factory, as shown in the
table below. Input the signals whose settings are to be stored into memory and adjust for the desired screen following the
instructions on adjusting the screen. Release the adjustment button to automatically store the level into memory. After
adjustment, when the same signals are input, they are displayed with the setting levels last stored into memory.
Factory-set signals
Mode Display
number (dots
1 852
2 640
3 640
4 640
5 720
640
6
640
7 640
8 640
9 800
10 640
11 640
12
13
14
15
16
Note 1: The dedicated graphics board is an optional product.
2: The 800 x 600 mode is compressed display through compression interpolation. Also, the screen
Points about usage
The company names and product names in this document are trademarks or registered trademarks of their respective com-
panies.
The mode numbers indicate the SIGNAL INFORMATION modes set for the RGB mode and input source.
4 0
Horizontal frequency
lines) (kHz)
480 31.72
480 31.47
480 37.86
480 37.50
400 31.47
480 34.97
480 35.00
400 24.83
400 31.50
600 35.16
480 15.73
480 15.63
15.63 to 60.00
display is also compressed for display.
Vertical frequency
(Hz)
Note1
59.97
59.94 VGA
72.81 VGA 72 Hz
75.00 VGA 75 Hz
70.09 VGA 400 lines
66.61 MAC 13RGB (1)
66.67 MAC 13RGB (2)
56.42 PC98 24kHz
70.15 PC98 31kHz
56.25 SVGA 56 Hz
59.94 60 fields
50.00 50 fields
50.00 to 75.00 User settings
Supported signal
When dedicated
graphics board used
Note2