www.ti.com
7. Install jumpers using the "factory settings" from
After completing these steps, the test setup for BMS051 is as shown in
Figure 2-2. Original Test Setup for BMS051 (BQ2573X EVM)
8. Turn on the computer and power supply #1. Open the BQstudio software.
a. Select Charger and click the Next button.
b. Select "Charger_1_00_BQ2573x.bqz" on the Select a Target Page.
c. After selecting the target device, change "update mode" from "immediate" to "manual", click "Read
Register" and the following interface is presented.
SLUUCB9A – JUNE 2020 – REVISED JANUARY 2021
Submit Document Feedback
Table
1-2.
Copyright © 2021 Texas Instruments Incorporated
Figure
2-2.
BQ2573X Evaluation Module
Test Summary
7