Installation Instructions; Leveling Instructions - Hamilton Beach HBFRF1705-WHITE Owner's Manual

Installation Instructions

Location
Two people should be used when moving the appliance.
■
Remove interior and exterior packaging prior to installation. Wipe the outside of the appliance with a soft,
■
dry cloth and the inside with a luke warm wet cloth.
Place the appliance on a floor that is strong enough to support it when it is fully loaded.
■
Do not place the appliance in direct sunlight or near sources of heat, such as a stove or heater, as this
■
can increase electrical consumption. Extreme cold ambient temperatures may also cause the appliance
to perform improperly.
Do not use the appliance near water, for example in a wet basement or near a sink.
■
This appliance is intended for household use only. It is not designed for outside installation, including
■
anywhere that is not temperature controlled (garages, porches, vehicles, etc.).
Before connecting the appliance to a power source, let it stand upright for approximately 6 hours. This
■
will reduce the possibility of a malfunction in the cooling system from handling during transportation.
This appliance is 76.1 cm (29.96 inches) wide by 170.9 cm (67.28 inches) high by 72.4 cm (28.50 inches)
■
deep. Make sure that you leave the minimum amount of space between the appliance and all surrounding
walls and vents.
Allow 12.7 cm (5 inches) of space between the back , sides and top of the appliance and all adjacent
■
walls.
This appliance is intended for free-standing installation only and is not intended to be built into a cabinet
■
or counter. Building in this appliance can cause it to malfunction.

LEVELING INSTRUCTIONS

There are two adjustable legs on the bottom of the appliance that can be turned up or down to ensure
that the appliance is level.
1. Turn the leveling leg counter-clockwise as far as it will go, until the top of the foot is touching the
bottom of the chassis.
2. Slowly turn the leveling leg clockwise until the appliance is level.
4
4