Table of Contents
Advertisement
VEHICLE CONTROLS
If you find the timing of beam changes inconvenient for driving, change the
beams manually.
For the system to work properly:
• Do not place an object that reflects light on the dashboard.
• Keep the windshield around the camera clean. When cleaning the windshield,
be careful not to apply windshield cleanser to the camera lens.
• Do not attach an object, sticker or film in the area around the camera.
• Do not touch the camera lens.
If the camera receives a strong impact or requires repair, consult a dealer.
If the Cannot Operate message appears, park
your vehicle in a safe place. Wipe away debris
blocking the windshield, then start driving again.
If the message remains on even after driving for a
while with the clean windshield, have your vehicle
checked by a dealer.
40 |
Interior Lights
Change the interior light settings using the switches on the ceiling.
Front lights
On position: Interior lights remain on.
Door-activated position: Interior lights come on
when any of the doors are opened, the driver's door
is unlocked, or the vehicle is turned off.
Off position: Interior lights remain off.
Map lights
Press the map light button to turn lights on or off.
Cargo lights
Located on the inside of the tailgate door.
On position: The light comes on when the tailgate
is open and goes off when it is closed.
Off position: The light stays off.
One-Touch Turn Signal
Use this quick and convenient method to signal a lane change.
Lightly push the turn signal lever up or down for a
three-blink sequence.
For a continuous signal, push the lever up or down
until it locks into place.
VEHICLE CONTROLS
Door-activated position
Off
On
Second- and third-rows
On
Off
Right
Left
| 41
Advertisement
Table of Contents
