Fujitsu Stylistic 5030 User Manual page 19

In the following table, a "blinking" LED flashes at the rate of once per second; an LED that is "blinking, slow" flashes at the
rate of one second on, five seconds off.
Icon Mode/State
Battery • On State
• Idle Mode
• Suspend-to-RAM,
without AC adapter
• Suspend-to-RAM
with AC adapter
• Hibernate
(Save-to-Disk),
with AC adapter
• Off State
• Hibernate
(Save-to-Disk),
without AC adapter
HDD • On State (or
flashing)
Access
• Idle Mode
• Suspend-to-RAM
• Hibernate
(Save-to-Disk)
• Off State
Security • On State
LED State
Green, continuous
Amber, continuous
Red, continuous
Red, blinking
Green, blinking slow
Amber, blinking slow
Red, blinking slow
Off
Green
Off
Green, continuous
(until password is
entered)
Table 1-2. System Status Indicators
G e t t i n g S t a r t e d
Remarks
Battery charge is between 50%-100%
Battery charge is between 13%-49%
Battery charge is between 0%-12%
There is a battery error.
Battery charge is between 50%-100%.
Battery charge is between 13%-49%.
Battery charge is between 0%-12%.
Battery is not installed, or system is off or in
Hibernate mode.
If battery is inserted during power off, LED blinks
amber for 4 seconds to detect battery. Battery
status is displayed for 5 seconds after that.
Displayed when hard disk drive is accessed.
Hard disk drive is not being accessed.
The Security Indicator lights (if a password was
set) when the system resumes from Off or
Standby modes. You must enter the password
that was set in the Security Panel before your
system will resume operation.
Functions of Application Buttons on page 14 for
more information.)
(See Security
9