Video Problems - Fujitsu Lifebook N3520 User Manual

Problem
Your LifeBook note-
book appears to change
setup parameters when
you start it.

Video Problems

Display is blank when
you turn on the system.
When the ATI Driver
CD is first installed, you
receive a Microsoft
message informing you
that the ATI driver is not
compatible with your
operating system.
The LifeBook notebook
turned on with a series
of beeps and your built-
in display is blank.
The display goes blank
by itself after you have
been using it.
Possible Cause
BIOS setup changes were not
saved when you made them and
exited the BIOS setup utility
returning it to previous settings.
The BIOS CMOS hold-up battery
has failed.
Something is pushing on the
Closed Cover switch.
The LifeBook notebook is set for
an external monitor only.
The angle and brightness settings
of the display are not adequate for
the lighting conditions.
The power management timeouts
may be set for very short intervals
and you failed to notice the
display come on and go off again.
The warning does not apply to
your LifeBook; the driver has
been thoroughly tested and its
installation will not jeopardize
the performance of your system.
Power On Self Test (POST) has
detected a failure which does not
allow the display to operate.
The LifeBook notebook has gone
into Video timeout, Standby
mode, Suspend mode or Hiber-
nation (Save-to-Disk) mode
because you have not used it for a
period of time.
Something is pushing on the
Closed Cover switch.
The power management timeouts
may be set for very short intervals
and you failed to notice the
display come on and go off again.
T r o u b l e s h o o t i n g
Possible Solutions
Make sure you select Save Changes And Exit when
exiting the BIOS setup utility.
Contact your support representative for repairs.
This is not a user serviceable part but has a normal
life of 3 to 5 years.
Clear the Closed Cover switch. (See Figure 2-3 on
page 8 for location)
Pressing [F10] while holding down the [Fn] key
allows you to change the destination of your display
video. Each time you press the combination of keys
you will step to the next choice. The choices, in
order, are: built-in display only, external monitor
only, both built-in display and external monitor.
Move the display and the brightness control until
you have adequate visibility.
Press any button on the keyboard, or move the
mouse to restore operation. If that fails, push the
Power/Suspend/Resume button. (The display may
be shut off by Standby mode, Auto Suspend or
Video Timeout)
If this message appears on your screen, click the
Continue Anyway or Yes buttons to proceed.
Contact your support representative.
Press any button on the keyboard, or move the mouse
to restore operation. If that fails, push the Power/
Suspend/Resume button. Check your power manage-
ment settings, or close your applications and go to the
Power Savings menu of the setup utility to adjust the
timeout values to suit your operation needs. (See
BIOS Setup Utility on page 29 for more information)
Check the Closed Cover switch. (See Figure 2-3 on
page 8 for location)
Press a keyboard button or move the mouse to restore
operation. If that fails, push the Power/Suspend/
Resume button. (The display may be shut off by
Standby Mode, Auto Suspend or Video Timeout)
69