Table of Contents
Advertisement
Fig. 7.3
Fig. 7.4
WARNING: Connect the hose directly to the water
n
inlet tap. The pressure supplied by the tap should be
a minimum of 0.03 MPa and a maximum of 1 MPa. If
the pressure exceeds 1 MPa, a pressure relief valve
must be fitted between the connection.
WARNING: After the connections are made, turn the
n
tap on fully and check for water leaks. Always turn
off the water inlet tap after a wash program has
finished (Fig. 7.3).
An Aquastop water spout is available with some
n
models. Do not damage it or allow it to become
kinked or twisted.
Drain Hose Connection
Connect the water drain hose directly to water drain hole or
to the sink outlet spigot. This connection should be minimum
50 cm and maximum 110 cm from floor plane (Fig. 7.4).
IMPORTANT: Items will not wash properly if a drain
n
hose longer than 4m is used.
Electrical connection
WARNING: Your machine is set to operate at 220-240
n
V. If the mains voltage supply to your machine is 110
V, connect a transformer of 110/220 V and 3000 W
between the electrical connection.
The earthed plug of the machine must be connected
n
to an earthed outlet supplied by suitable voltage
and current.
In the absence of earthing installation, an
n
authorised electrician should carry out an earthing
installation. In the case of use without earthing
installed, we will not be responsible for any loss of
use that may occur.
The indoor fuse current value should be 10-16 A.
n
The plug on this appliance may incorporate a 13A
n
fuse depending on the target country (for example
UK, Saudi Arabia).
17
Advertisement
Table of Contents
