Connection Using Windows 2000; Flow Of Operations; Preparation For Wireless Lan Connection - Fujitsu Lifebook C2220 User Manual

Brie3-B5FH-8711.book Page 60 Wednesday, May 14, 2003 10:37 AM
L i f e B o o k C S e r i e s N o t e b o o k – S e c t i o n F i v e

Connection using Windows 2000

FLOW OF OPERATIONS

The wireless LAN connection procedure is outlined
below.
1. Make sure that the personal computer is ready for
the transmission of radio waves from the wireless
LAN. For further details, see "Starting the transmis-
sion" on page 54.
2. Assign the parameters required for wireless LAN
connection. For further details, see "Preparation
for wireless LAN connection" on page 55.
Enter the network name (SSID) and other data.
Enter the network key (the key to be used to
encode communications data).
3. Perform setting operations relating to network con-
nection. For further details, see "Connection to the
network" on page 57.
Specify TCP/IP as the protocol, and confirm the
name of the work group and other settings.
Enter the data required for file/printer sharing on
the network. Perform this operation as required.
For infrastructure connection, enter data for the
access point. Refer to the manual of the access
point for further details.
Verify that you have been able to connect your
computer to the network.
PREPARATION FOR WIRELESS LAN
CONNECTION
This section explains the preparation (parameter assign-
ment) required for the use of the wireless LAN.
Assigning parameters
Enter the network name (SSID), the network key, and
other data required for wireless LAN connection. If there
is the administrator of the network, contact the network
administrator for data settings.
60
P O I N T S
Wireless channels 1 to 11 are used for the
IEEE802.11b-compliant wireless LAN adopted by this
personal computer. If you are to use infrastructure
connection (network connection via a access point), a
channel number greater than 11 may have been pre-
assigned or automatically assigned to the wireless
channel to be used for the access point.
In such a case, set the channel of the access point to
either from 1 to 11. For further details of the setting
method, refer to the manual of the access point you
are using.
To use infrastructure connection, refer to the manual
of the access point for the access point-setting proce-
dure.
In the case of infrastructure connection, to use ADSL
(PPPoE) for accessing the Internet, the MTU size of
this personal computer needs to be changed. For fur-
ther details, refer to the manual of the access point.
1. Right-click the Broadcom Wireless Utility icon in
the system tray in the lower right corner of your
screen.
2. Click [Open Utility]. The [Broadcom Wireless
Configuration Utility] window will be displayed.
3. Select the [Wireless Networks] tab if it is not
already selected.
4. Click the [Add] button. The Wireless Network
Properties window will appear.
5. Enter the information required for connection to
the wireless LAN:
Network name (SSID)
Enter the appropriate network name according to
the "Operating mode" to be used. Enter the desired
network name in less than 33 ASCII characters.
Infrastructure connection:
Assign the appropriate data according to the ID
code of the access point to be accessed. For access
point setting, refer to the manual of the access
point.
Ad hoc connection:
Assign the same network name to all the personal
computers to be connected. Check the box that says
[This is a computer-to-computer (ad hoc) net-
work...]