Connecting Windows Xp Systems - Fujitsu Lifebook C2010 User Manual

B5FH-5971.book Page 59 Thursday, May 23, 2002 4:13 PM
Item
State Shows the current condition of
connection.
The MAC address of the other
computer to which you are
connected is displayed when the
connection is successful. If you are
connected to more than one
computer, the computer that has
the best connectivity is displayed.
Current Channel Shows the current channel used
for the connection.
Current Tx Rate Shows the current transfer rate in
Mbits/sec.
[Radio Off]/ Click [Radio Off] to disconnect.
[Radio On]
Click [Radio On] to connect to the
network.
[Rescan] button Click this button to search for
others to connect to.
Throughput Shows the actual transfer rate of
(Bytes/sec) the data transfer for send (Tx) and
receive (Rx).
Link Quality Shows either [Excellent], [Good],
[Fair], [Poor], or [Not Connected],
depending on the link quality.
Not shown for AdHoc connection.
Signal Strength Shows either [Excellent], [Good],
[Fair], [Poor], or [Not Connected],
depending on the signal strength.
Not shown for AdHoc connection.
Table 9: Checking connectivity

CONNECTING WINDOWS XP SYSTEMS

This chapter describes how to set up the wireless LAN
connection for computers that are running Windows XP.
Description
When you receive your LifeBook, the integrated
wireless LAN device and drivers have already been
installed. This procedure outlines the steps for setting
the device parameters.
Updated drivers and/or utilities may become available
after this manual is printed; see any addenda or fliers
that may be included in the system packaging.
Workflow
The proper setup of the wireless LAN connection
requires that several steps be performed in the proper
order. Following is a general outline of the steps to be
performed. Each step is detailed later in this procedure.
1. Setting parameters
I
I
2. Network settings
I
I
I
Setting Parameters
1. Click [Start] -> [Control Panel].
2. Click [Network and Internet connection].
3. Click [Network connection]. A list of networks that
4. Right click [Intersil PRISM Wireless LAN PCI Card]
5. Click the [Wireless Networks] tab. The [Wireless
6. Perform the following steps.
I
I
7. Set parameters.
I
I
U s i n g t h e W I r e l e s s L A N
P O I N T
Setting the profile
Setting the encryption
Setting the protocol and checking the network
Setting file and printer sharing
Checking the connection
are currently installed is displayed.
in the list, and click [Properties] from the menu that
is displayed. [Wireless Network Connection 2 Prop-
erties] appears.
Networks] tab appears.
Make sure that [Use Windows to configure my wire-
less network settings] is checked.
Click [Add] under [Preferred networks]. [Wireless
Network Properties] appears.
For the AdHoc network, specify the same value to all
the computers, for which the encryption key is used
for connection.
For the infrastructure network, specify the encryp-
tion key (network key) with the same value to the
encryption key of the access point. For how to check
the encryption keys set for the access point, refer to
the manual supplied with the access point.
59