Fujitsu Lifebook B2620 User Manual page 101

AdHoc Network: Select [IP address], and enter a
■
value for [IP address] and [Subnet Mask]. Refer to
"About IP Addresses" on page 27 to set an IP address
and subnet mask.
Infrastructure Network: Select [Obtain an IP
■
address automatically].
5. Click [OK]. [Network] appears again.
In the next step, you will check the computer name and
workgroup.
Checking the Computer Name and Workgroup
1. Click the [Identification] tab on the [Network]
window.
P O I N T
If this tab is not found on the [Network] window, click
[Start] -> [Settings] -> [Control Panel], and double-
click the [Network] icon.
2. Check the entry for [Computer name] and [Work-
group]. Ask your network administrator and check
the setting, if you have a network administrator.
Item
Computer A name to identify the computer on
Name the network. You can specify any
name for any computer. Use up to 15
single-byte characters. For easiest
identification, use the model name or
user name.
Workgroup The name of the network group. Use
up to 15 single-byte characters.
■ AdHoc Network: Specify the same
name to all computers within the
same network.
■ Infrastructure Network: Specify a
workgroup name to connect to.
Computer Additional description for the
Description computer. This is not necessary.
Table 10: Computer Name and Workgroup
P O I N T
Including a period or other special characters may
prevent you from connecting to the network.
3. Click [OK]. When a message appears prompting you
to restart the computer, click [Yes].
Sharing
In this section, you set sharing of the drive, folder, and
printer.
Description
W I r e l e s s L A N U s e r ' s G u i d e
You need to set this only when you are sharing files or a
printer with other computers on the network. When you
share a drive, folder, or printer, you can use these from
any computer on the network.
Setting File and Printer Sharing for Networks
1. Click [Start] -> [Settings] -> [Control Panel].
2. Double-click the [Network] icon. The [Network]
window appears.
3. Click [File and Print Sharing...]. [File and Print
Sharing] appears.
4. Click and check one or both of the options.
5. Click [OK]. [File and Printer Sharing for Microsoft
Networks] is added under [The following network
components are installed] on [Configuration] tab.
6. Click [OK]. [Network Properties] closes. Follow the
instructions on the screen.
7. When a message appears prompting you to restart
the computer, click [Yes].
Sharing Files
The following example shows how to set sharing the
"Work" folder on the c drive.
1. Double-click [My Computer] -> [C: drive] on the
desktop.
2. Right-click the "Work" folder, then click [Sharing]
from the menu that appears. The [Work Properties]
window appears.
3. Click [Sharing], and select items, as specified below.
Item
Share Name Specify a share name for the drive or
folder that you want to share.
Access Type Limits the read/write permission for the
drive to be shared.
■ Read-Only Password: Specifies read-
only for the drive to be shared.
Full Access Password: Allows read
■
and write for the drive to be shared.
■ Depends On Password: Identifies
either Read-Only or Full, depending
upon the password.
Passwords A password used for [Access Type].
■ Read-Only Password: Specify a pass-
word to allow read.
■ Full Access Password: Specify a pass-
word to allow read and write.
Table 11: Password Setup
4. Click [OK]. The folder is set for sharing, and the
"Work" folder icon changes.
Description
95