Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for AEG FAVORIT 40740
Summary of Contents for AEG FAVORIT 40740
- Page 1 FAVORIT 40740 Dishwasher User Instructions...
- Page 2 In the event of a malfunction, these operating instructions contain information on how to rectify faults yourself, see the "What to do, if..." section. If these instructions are insufficient, please contact your AEG Service Force Centre. In this respect please read the chapter "Service & Spare Parts".
-
Page 3: Table Of Contents
CONTENTS Operating Instructions Safety Instructions ..........Disposal . - Page 4 Contents Care and Cleaning ..........30 Cleaning the Filter .
-
Page 5: Operating Instructions
OPERATING INSTRUCTIONS Safety Instructions The safety aspects of AEG electrical appliances comply with accepted technical standards and the German Appliance Safety Law. Neverthe- less, as a manufacturer we consider it our obligation to make you aware of the following safety information: Installation, Connection and Placing into Operation •... -
Page 6: Correct Use
• If the mains lead is damaged, or is to be replaced for a longer lead, the cable (obtainable from AEG Service Force) must be replaced by a service engineer authorised by AEG. • Never unplug the appliance by pulling on the cable, always pull the plug. -
Page 7: Disposal
• In the event of a fault, first close the tap, then switch off the appli- ance and unplug it from the mains. If the appliance is permanently wired to the mains: remove the fuse. Disposal Disposing of the Packaging Material Dispose of the dishwasher packaging material correctly. -
Page 8: Appliance Features And Control Panel
Operating Instructions Appliance Features and Control Panel Top Spray Nozzle Rubber Seal for Connecting the Water Feed to the Spray Arm Spray Arms Water hardness switch Container for Salt Container for Detergent Container for Rinse Aid Filters Rating Plate... -
Page 9: Control Panel
Control panel Water sof- Function To set tener button button delay start Wash programme buttons Control indicators Water softener and function button: In addition to the wash pro- gramme marked, it is also possible to adjust the dishwasher's water sof- tener using a combination of these buttons. -
Page 10: Prior To Using For The First Time
Operating Instructions Prior to using for the first time Prior to using for the first time, remove all the clips with which the baskets are secured for transport. Then perform the following steps: 1. Adjust the water softener 2. Fill the water softener with water and special salt 3. -
Page 11: Setting The Water Softener
1) (°d) German degree, measure of the hardness of water 2) [mmol/l] millimol per litre, international unit for the hardness of water 3) On this setting the length of the wash programme may be slightly longer. *) factory setting Setting the water softener Using the table as a guide, adjust the water softener to that which cor- responds to the hardness of the water in your area: The dishwasher must be switched off. -
Page 12: Special Salt For The Water Softener
Operating Instructions Special salt for the water softener If the water hardness in your area is less than 4 °d, then the water in your dishwasher does not need to be softened and you do not need to use special salt or salt substitute. Water can be softened in one of two ways: •... -
Page 13: Adding Special Salt
Adding special salt If you are using dishwasher detergent and special salt separately, add the special salt: – Before using the dishwasher for the first time. – When the indicator for special salt panel. 1. Open the door, remove the lower basket. -
Page 14: Rinse Aid
Operating Instructions Rinse aid Rinse aid ensures thorough rinsing and spot and streak free drying of dishes and glassware. Rinse aid can be added in one of two ways: • If you are using dishwasher detergent that already contains rinse aid, the detergent including the rinse aid is put into the detergent com- partment. -
Page 15: Adding Rinse Aid
display will indicate the current setting: indicator is illumi- nated: indicator is not illu- minated: 4. Pressing function button 2 activates and deactivates the rinse aid dis- pensing function. 5. If the rinse aid dispensing function has been correctly set, press the ON/ OFF button. -
Page 16: Adjusting Rinse Aid Dosing
Operating Instructions 4. Fill with rinse aid exactly up to the level marked “max”; this corresponds to a quantity of approx. 140 ml. 5. Close the lid and press until it locks into place. 6. Wipe up any spilt rinse aid with a cloth. -
Page 17: In Daily Use
In Daily Use • Check the salt and rinse aid levels. • Load cutlery and dishes into the dishwasher • Fill with dishwasher detergent • Select a wash programme suitable for the cutlery and dishes • Start the wash programme Loading Cutlery and Dishes Sponges, household cloths and any object that can absorb water should not be washed in the dishwasher... -
Page 18: Loading Cutlery
Operating Instructions Loading Cutlery Long bladed knives stored in an upright position are a potential hazard. Long and/or sharp items of cutlery such as carving knives must be positioned horizontally in the upper basket. Take care when loading or unload- ing sharp items such as knives. -
Page 19: Loading Pans, Frying Pans And Large Plates
Loading Pans, Frying Pans and Large Plates Load large and heavily soiled dishes in the lower basket (Plates up to 29cm in diameter). Your dishwasher has one of the following four types of lower basket: Type 1: None of the plate inserts in the lower basket can be removed Type 2: The right-hand plate inserts in the lower basket can be folded over to the left To ease the loading of large items,... - Page 20 Operating Instructions Type 3: The right-hand plate inserts in the lower basket can be folded across one another To ease the loading of large items, the two right-hand plate inserts in the lower basket can be folded across one another. Type 4: The two rear plate inserts in the lower basket can be folded across one another To ease the loading of large items,...
-
Page 21: Loading Cups, Glasses And Coffee Services
Loading Cups, Glasses and Coffee Services Load small, delicate items and long pointed cutlery in the upper basket. • Arrange items of crockery on the folding cups racks so that they are offset from each other and water can reach all items. •... -
Page 22: Adjusting The Height Of The Upper Basket
Operating Instructions Adjusting the Height of the Upper Basket With upper basket raised With upper basket lowered The height of the basket can also be adjusted when it is loaded. Lowering the Upper Basket: 1. Pull the upper basket out completely. 2. -
Page 23: Filling With Detergent
Filling with Detergent Only use dishwasher detergent. Fill with detergent: – Prior to the start of a wash programme (not for the pre wash pro- gramme). The detergent is released into the wash water during the programme. Please observe the manufacturer's dosing and storage recommenda- tions as stated on the detergent packaging. -
Page 24: Use Of "3 In 1"/ Combi Detergent Tablets
Operating Instructions Use of "3 in 1"/ Combi Detergent Tablets General Advice These products are tablets with combined detergent/rinse-aid and salt functions. 1. Before using these products you should first check that the water hard- ness in your supply is compatible with the use of these products as per the detergent manufacturers instructions (on the product packaging). -
Page 25: Concentrated Detergent
Concentrated Detergent Based on their chemical composition, dishwasher detergents can be split into two basic types: – conventional, alkaline detergents with caustic components – low alkaline concentrated detergents with natural enzymes. The use of 50 °C wash programmes in conjunction with concentrated detergents reduces pollution and is good for your dishes;... -
Page 26: Selecting The Wash Programme (Programme Table)
Operating Instructions Selecting the Wash Programme (Programme Table) Choose the most suitable wash programme with the aid of this table: Dinner Service Type of Dishes and Cooking Utensils In Addition Type of Soiling • heavily soiled • dried on left- overs, particularly egg white and thickeners... -
Page 27: Starting A Wash Programme
Starting a wash programme 1. Check that the dishes and cutlery are stacked in the dishwasher in such a way that the spray arms are free to rotate. 2. Turn on the water tap fully. 3. Close the door. 4. Press the ON/OFF button. The LED in the ON/OFF button will illuminate. -
Page 28: Setting Or Changing The Start Delay
Operating Instructions Interrupting the wash programme by opening the dishwasher door Hot steam may escape when the door is opened. There is a risk of scald- ing. Open the door carefully. 1. Open the door of the dishwasher. The wash programme will stop. 2. -
Page 29: Load Sensing - Sensor Logic
Changing the wash programme after the start delay has been set: As long as the wash programme has not yet started, you are able to change the programme set by pressing a wash programme button. 1. Press the button for the new wash programme and hold it down. First, the indicator for the wash programme that was already selected will flash. -
Page 30: Care And Cleaning
Operating Instructions Care and Cleaning Do not under any circumstances use furniture care products or aggres- sive cleaners. • If necessary, clean the controls only with a soft cloth and pure warm water. • Occasionally check the internal containers, door seal, and water inlet for soiling, clean if necessary. - Page 31 7. Put the flat filter back in the base of the washing compartment 8. Place the coarse/fine filter in the microfilter and press together. 9. Put the filter combination in place and lock by turning the handle clock- wise to the stop. During this process ensure that the flat filter does not protrude above the base of the wash- ing compartment.
-
Page 32: What To Do, If
Operating Instructions What to do, if ... Try to rectify minor faults on the dishwasher with the aid of the instructions given here. If you call an engineer to resolve a of fault listed here, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is in guarantee. - Page 33 Malfunction The programme indicator for the selected wash pro- gramme is flashing, the end wash programme indicator is flashing in the following sequence: 2 short flashes one after the other. The end wash programme indicator is flashing in the following sequence: 3 short flashes, one after the other.
-
Page 34: There Are Problems With The Operation Of The Dishwasher
Operating Instructions ...there are problems with the operation of the dish- washer. Symptom The programme does not start. Rust spots are visible in the washing compart- ment. There is a whistling noise during washing..the wash results are not satisfactory. The dishes are still dirty. -
Page 35: Technical Data
The dishes are wet and dull. – Rinse aid was not used. – The rinse aid container is empty. There are streaks, milky spots or a bluish coating on glasses and dishes. – Lower rinse aid dosing. There are dried water drops on the glasses and dishes. –... -
Page 36: Notes For Test Institutes
Operating Instructions Notes for Test Institutes Testing in accordance with EN 60704 must be carried out with the appliance fully loaded and using the test programme (see Programme Table). Tests in accordance with EN 50242 must be carried out when the salt dispenser and rinse aid container have been filled with salt and rinse aid respectively and using the test programme (see Programme Table). -
Page 37: Installation And Connection Instructions
INSTALLATION AND CONNECTION INSTRUCTIONS Installing the Dishwasher • The dishwasher must be installed on a firm floor and adjusted such that it is stable and level. • To compensate for unevenness in the floor and to match the height of the appliance to that of surrounding units extend the threaded feet by unscrew- ing:... - Page 38 Installation and Connection Instructions If the dishwasher is installed underneath a kitchen work surface, the original work surface of the dishwasher is to be removed as follows: 1. Unscrew the screws from the posi- tioning plates on the back (1). 2.
-
Page 39: Connecting The Dishwasher
Connecting the Dishwasher Water Connection The dishwasher is fitted with safety devices that prevent the wash water returning into the drinking water system and comply with the applicable plumbing regulations. • The dishwasher must be connected to a cold water supply. •... -
Page 40: Water Inlet Hose With Safety Valve
Installation and Connection Instructions The following section is only applicable to dishwashers that have a safety valve on the threaded hose fitting for the tap: Water inlet hose with safety valve After connecting the double-walled water inlet hose, the safety valve is next to the tap. -
Page 41: Water Drain
– Minimum required height 40 cm above the lower edge of the machine. Extension hoses • Extension hoses are available from AEG Service Force. The internal diameter of the extension hoses must be 19 mm to ensure that the function of the appliance is not impeded. -
Page 42: Leak Prevention System
Installation and Connection Instructions Leak Prevention System For protection from damage due to water leaks, the dishwasher is equipped with a leak prevention system, the AQUA CONTROL SYSTEM. In the event of a fault, the safety valve in the appliance immediately interrupts the inflow of water and the drain pump is activated. -
Page 43: Electrical Connection
Electrical Connection Any electrical work required to install this appliance should be car- ried out by a qualified electrician or competent person. WARNING - This appliance must be earthed. The manufacturer declines any responsibility should these safety measures not be observed. Before switching on make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. -
Page 44: Connections
Installation and Connection Instructions Connections The water inlet and drain hoses, as well as the mains cable must be connected beside the dishwasher as there is insufficient space behind the appliance. The plumbing and electrical installation example given below can only be regarded as a recommendation. -
Page 45: Guarantee Conditions
GUARANTEE CONDITIONS Standard guarantee conditions We, AEG, undertake that if within 12 months of the date of the purchase this AEG appliance or any part thereof is proved to be defective by reason only of faulty work- manship or materials, we will, at our discretion repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: •... -
Page 47: Service And Spare Parts
Please note that a valid purchase receipt or guarantee documentation is required for in-guarantee service calls. Customer Care For general enquiries concerning your AEG appliance or for further information on AEG products please contact our Customer Care Department by letter or telephone at the address below or visit our website at www.aeg.co.uk. - Page 48 USD 14 billion in more than 150 countries around the world. AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www.aeg.hausgeraete.de © Copyright by AEG 822 961 070 -00- 0603 Subject to change without notice...