Tools You Will Need - Canon COLORPASS-Z6000 PS-NX6000 Installation And Service Manual

xiv
Preface
• When you unpack the ColorPASS from the carton for the first time, touch a metal area
of the copier to discharge the static on your body.
• Before you remove the side panel(s) and handle internal components, touch a metal
part of the ColorPASS.
• Leave new electronic components inside their antistatic bags until you are ready to
install them. When you remove components from an antistatic bag, place them on a
grounded antistatic surface, component-side up.
• When you remove an electronic component, place it into an antistatic bag
immediately. Do not walk across a carpet or vinyl floor while carrying an unprotected
board.
• Do not damage or remove the gaskets affixed to one edge of the side panels and around
the DVD (digital video disk) drive enclosure. The gaskets are designed to reduce
possible electromagnetic interference (EMI).
• Handle printed circuit boards by their opposing edges only, and avoid touching the
contacts on the edge of the board.
• Protect the thermal material on the base of the heatsink. If you remove the CPU
cooling assembly (for instance, when transferring the CPU to a new motherboard),
avoid touching the thermal material on the base of the heatsink. When setting the
heatsink aside, set it base-side-up.
• Never set any liquid on or near the ColorPASS or the copier.

Tools you will need

To install or service the ColorPASS, you should bring the following tools and parts:
• ESD wrist grounding strap and antistatic mat
• Wire cutters
• Needlenose pliers
• #0 and #1 Phillips head screwdrivers (non-magnetic)
• Flathead screwdriver
You should also bring this guide, documentation for any optional service kits you may be
installing, and any technical notes for the ColorPASS.