Sharp LC-70UD1U Service Manual page 21

2.2.3 How to upgrade the software
1. Unplug the AC cord.
2. Insert the USB Memory for version upgrade into the service socket.
3. Plug in the AC cord with power button pressed down.
4. After 5 seconds, unpress the power button.
5. After the unit startup, the system upgrade screen as shown below within 20-40 seconds.
6. Even a single failure in the process will trigger the upgrade failure screen.
NOTE: In the event of a failure, repeat the upgrade process. If the process repeatedly fails, it is likely that the hardware need fixing.
7. Upon completion of the whole process, the upgrade success screen as shown below appears. You can check the new software version on this
screen. The version information appears after the upgrade is complete.
8. Unplug the AC cord and remove the USB Memory for version upgrade.
9. Now the software version upgrade is complete.
NOTE: When you are done with the software version upgrade, start the set, go to the top page of the adjustment process screen and check the main
software version information.
Software Update
MAIN
SAME VERSION
SUB MICOM
PANEL EEPROM
3D IR MICOM
103U1301111
MAIN Version
SUB MICOM Version
PANEL EEPROM
3D IR MICOM Version
Software Update
UPGRADE FAILURE
MAIN
SUB MICOM
PANEL EEPROM
3D IR MICOM
MAIN Version
SUB MICOM Version
PANEL EEPROM
3D IR MICOM Version
Software Update
UPGRADE SUCCESS
MAIN
SAME VERSION
SUB MICOM
PANEL EEPROM
3D IR MICOM
103U1301111
MAIN Version
SUB MICOM Version
PANEL EEPROM
3D IR MICOM Version
5 – 2
70UD1U
26%
NO DATA
70UD1U
Project ID
NO DATA
NO DATA
70UD1U
100%
NO DATA
LC-70UD1U