Table of Contents
Advertisement
3.
Remove the display assembly (4).
4.
If it is necessary to replace the display bezel or any of the display assembly subcomponents:
a.
Remove the two screw covers (1) and the two Phillips PM2.5×5.0 screws (2) that secure the
display bezel to the display assembly. (The screw covers are available in the Display Rubber
Kit, spare part number 641810-001.)
b.
Flex the inside edges of the top edge (1), the left and right sides (2), and the bottom
edge (3) of the display bezel until the bezel disengages from the display enclosure.
Component replacement procedures
105
Advertisement
Table of Contents
