Set Clock; Weight Sensor - Whirlpool JQ 276 Instructions For Use Manual

All manuals and user guides at all-guides.com
W
product will enter clock setting. If the clock is not set, the display
will remain ":" instead of the clock.
NOTE:
standby mode to access the clock setting mode.
q
w
e
r
T
I
F
the display shows ":".
N
minutes to complete the setting of the Clock. Otherwise, each step
must be accomplished within 60 seconds.
T
HIS MICROWAVE OVEN USES THE WEIGHT SENSOR TECHNOLOGY
and Steam); when you select one of these 6thSense functions, you just need to select type of
food you want to process and press start: the microwave automatically detects the weight of
food and set the cooking time accordingly.
D weight icon blinks and progress bar shows the
URING THE SENSING PHASE
weight calculation process (see sample below, from 6th Defrost function).
WEIGHT SENSING CALIBRATION
Weight sensor technology requires a Calibration process before fi rst use.
Suggest user to make the calibration once a year.
T
HE CALIBRATION PROCESS MUST BE DONE
P for few seconds the Stop TurnTable button.
RESS AND HOLD
T starts and the display shows:
HE CALIBRATION PROCESS
-- weight icon blinking
-- calibration progress bar
W is fi nished, the Microwave returns to stand by mode.
HEN THE CALIBRATION PROCESS
10

SET CLOCK

HEN THE APPLIANCE IS FIRST PLUGGED IN
P &H
YOU CAN RESS OLD FOR A FEW SECONDS THE
T A to set the hours.
URN THE DJUSTABLE KNOB
P . (The two right-hand digits (minutes) flicker).
RESS KNOB BUTTON
T A to set the minutes.
URN THE DJUSTABLE KNOB
P .
RESS THE KNOB BUTTON AGAIN
and in operation.
HE CLOCK IS SET
STOP is pressed in clock setting mode, the clock will be disabled
: K
OTE EEP THE DOOR OPEN WHILE SETTING THE

WEIGHT SENSOR

for some 6th sense functions (Defrost, Crisp
with only the Turn Table glass in the cavity.
GB
or after a power failure, the
S in
TOP BUTTON
C . This gives you 10
LOCK