Frigidaire A21513101 Use & Care Manual page 15

Spray Arm
varies by model
To empty the glass trap:
1. Grasp the glass trap's handle
and rotate it 90
pressing down on the center of the
wash arm.
2. Grab the spray arm in the center
and lift the spray arm and glass
trap assembly up and out from the
dishwasher.
3. Tip the assembly over an
appropriate container and tap it to
empty the glass trap OR, separate
the glass trap - pull the glass trap
handle toward you, then up, then
further toward you to slide it away
from the rest of the assembly; empty
it into an appropriate container; then
slide the glass trap back into the
assembly.
4. Place the assembly back into
position, press down on the arm
at the center and rotate the glass
trap handle 90
being sure the glass trap ends in
the orientation shown in the image
above. To avoid damage to your
unit make sure the spray arm and
glass trap are fully snapped in place.
(2)
(3)
Glass Trap
(1)
Glass Trap Removal
clockwise while
0
counterclockwise
0
CARE AND CLEANING
WARNING
Allow heating element to
cool before cleaning the
interior.
Failure to do so can result in
burns.
Outer Door - Clean outer door with warm
soapy water and a dishcloth or sponge.
Rinse with clean water and a dry cloth.
Do not use harsh cleaners.
Inside - The inside of the dishwasher and
filter are self-cleaning with normal use.
If needed, clean around the tub gasket
area with a damp cloth. The filter is
self-cleaning. A glass trap located in the
center of the filter is designed to collect
pieces of broken glass, straws, bones and
pits.
Overfill Protector- keeps dishwasher from
overfilling and is located in the left front
corner of the tub.
• Clean occasionally with household
cleaner containing vinegar or bleach
to dissolve any buildup.
• Overfill Protector should move up
and down freely about one inch.
If it does not move, lift and clean
underneath.

NOTE
Hard water may cause lime deposit
buildup on the interior of the
dishwasher. For cleaning instructions
see "Removing Spots and film" section.
15
Burn Hazard