Table of Contents
Advertisement
Picture
Mode - Stardard
Picture
Peak white (nits)
Color
Contrast
Audio
Blue Light
G-Sync® Processor
Dark Boost
Gaming
SDR/HDR Variable Backlight
OSD
Backlight Response
System
Auto Brightness
Max Brightness
Move
Enter
1.
Press the MENU key to open the OSD.
2.
Toggle the joystick to the up or down to select Picture from the OSD.Then toggle to the right to navigate to the element you wish to
adjust and press the joystick to enter it.
3.
Toggle to the left or right to adjust the sliding scales.
4.
The Picture menu can be used to adjust the Peak white (nits), Contrast,Blue Light, Dark Boost, SDR/HDR Variable Backlight,
Backlight Response, Auto Brightness.
5.
Peak white (nits): Adjust the brightness
-----------------------------------------------------------------------------------------------------------
Note: Adjusts the balance between light and dark shades.
6.
Contrast: Adjust the contrast from 0 to 100.
-----------------------------------------------------------------------------------------------------------
Note: Sets the degree of difference between light and dark areas.
7.
Dark Boost: Dark Boost adjusts the lower half of the nominal EOTF gamma curve so that dark values appear brighter on screen.
8.
Blue Light: Filters out blue light to protect your eyes by adjusting how much blue light is shown --- Off, 80%, 70%, 60%, or 50%.
-----------------------------------------------------------------------------------------------------------
Note: Higher values allow more blue light through. For the best protection select a lower value.
When "Blue Light" is on, Brightness & Contrast will show each level of "Blue Light" value.
50 % is compliance with TUV Low Blue Light Certification.
9.
SDR/HDR Variable Backlight: Adjust Variable mode backlight ON/OFF.
10. Backlight Response: This sets the basic response time to the variable backlight.
11. Auto Brightness: NVIDIA function.
Display maximum luminance control (automatic brightness control)
Off: Use fixed value.
On: Use automatic value guided by light sensor.
Default is: On
12. Max Brightness
Default: OFF
Off: Lower brightness
On: Restore original brightness.
When "Max Brightness" be changed, "Modes" will be reset to "Standard".
X38 User Guide English
315
50
Off
Off
On
Mode1
On
Off
from 40to 157.
12
Advertisement
Table of Contents
