Answering System Operation; Setting The Day/Time Stamp; Recording Your Outgoing Messages - BellSouth GH9488 Owner's Manual Installation And Operating Instructions

Answering System Operation

IMPORTANT: To ensure the proper operation of your Answering System,
1. Press the RESET button at the back of the BASE UNIT before initial use.
2. Wait for at least 45 seconds after plugging the AC ADAPTOR into the
POWER-IN CONNECTION JACK before operating your Answering System.

Setting the Day/Time Stamp

Press and hold down the
day and time." Then, enter the current day and time.
Press the button to confirm the selected day and time. The system will announce
the set day and time.
NOTES:
1. The HANDSET and BASE UNIT clock are independent from each other. Set the
BASE UNIT clock by following the time setting on the HANDSET clock.
2. In case of power failure, reset the time setting on the BASE UNIT clock.

Recording Your Outgoing Messages

Your Answering System provides one PRIMARY MAILBOX and four individual
MAILBOXES (1, 2, 3, 4) which can receive their own Incoming Messages (ICM). Before
using your Answering System, it is suggested that you record an Outgoing Message
(OGM). This is the announcement callers will hear when the system answers a call.
A prerecorded system announcement "Please record your message after the beep" is
available if you choose not to record your own OGM.
button until you hear the announcement "Please enter the
1. Day Setting
Press and hold down the
The corresponding day will be
displayed and announced. Release the
button when the desired day is
mentioned.
2. Hour Setting
Press and hold down the
The corresponding hour will be
displayed and announced. Release
the button when the desired hour is
mentioned.
1
3. Minute Setting
2
3
Press and hold down the
The corresponding minute will be
displayed and announced. Release the
button when the desired minute is
mentioned.
28
button.
button.
button.