Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Connection Kit
Parts included in the package
See Table 1.
Table 1
Parts
Figure
Wire
(with a
noise filter)
Installation
instructions
Installing the connection kit
A. 7000 BTU, 9000 BTU, and 12000 BTU inverter models
(1) Remove the air intake grille.
(2) Remove the terminal cover. Pull out the thermistor, then remove the grille.
For details on steps (1) and (2), refer to the Installation Instructions
included in the outdoor unit package.
(3) Disengage the top cover from the tabs on the sides of the component
box, then pull the cover toward you to remove it. (Fig. 1)
(To disengage the tabs, pull the sides of the top cover sideways and out-
ward from the component box.)
(4) Remove the 4 component box
installation screws. (Fig. 1)
(5) Disconnect the indicator-side connec-
tor (10P) of the wires that connect the
indicator and component box (Fig. 2a).
Then disconnect the connector on the
component box side (10P) and remove
the wires. (Lifting the P.C. board up
slightly will make this work easier.)
(Fig. 2b)
(6) After removing the wires, insert
Connector 1 of the wires (Fig. 3a) that
were included in the kit package into
the indicator (Fig. 2a), then insert
Connector 2 into the component box.
(Fig. 2b)
At this time, pass the wires through so
that they are held inside the 2 holders
on the sides of the component box.
(Fig. 3b)
85264190590000 2011
Q'ty
Parts
Figure
Truss-head Phillips
5/32 13/32"
Tapping
(4 10mm)
screw
1
Clamp
Label
1
Indicator
Connector 3
(4P)
Noise filter
Connector 1
(10P)
Q'ty
Parts
Figure
Clamping
1
strap
7-3/32"(180mm)
2
Wire tube
1
Tab
Screw
Connector (10P)
Fig. 2a
Connector 2
(10P)
Fig. 3a
Q'ty
1
1
Top cover
Screw
Component box
Fig. 1
P.C. board
Connector (10P)
Fig. 2b
Fig. 3b
CV6233187907
Holder
Advertisement
Table of Contents
