Table of Contents
Advertisement
Care and Cleaning
Interior, Exterior and Door
If walls, floor, and door of microwave oven become
splattered, wipe with paper towel or clean with mild
detergent in warm water using soft sponge or cloth.
Wring sponge or cloth to remove excess water
before wiping unit. If desired, boil a cup of water in
microwave oven to loosen soil before cleaning:
•
Do not use cleaners containing ammonia.
These could damage finish.
•
Never pour water into microwave oven bottom.
•
Do not use water pressure type cleaning
systems.
Discharge Air Vents
There will be a slight buildup of cooking vapors along
discharge louvers in back of oven on right side.
Clean air vent with damp cloth and dry.
Replacing Oven Light Bulb
Caution
To avoid electrical shock hazard
unplug power cord or open circuit
breaker to microwave oven before
replacing light bulb. After replacing
light bulb, reconnect power.
Tools needed--
•
protective gloves
•
flat blade screwdriver
•
120 volt, 40 watt,
appliance bulb (usually found at grocery or
hardware stores)
Splatter Shield
Splatter shield keeps top of microwave oven and
antenna from getting soiled. Remove soil from shield
with damp cloth. Remove splatter shield to clean
more thoroughly.
Important
When removing and replacing splatter shield, be
careful not to bend antenna.
1. Unplug oven before removing splatter shield to
stop antenna from rotating.
2. Shield snaps into lip in front of microwave oven
and three slots in back. To remove, place
thumbs into two indentations in front of shield.
Press lightly toward back and carefully lower
shield away from antenna.
3. Pull shield forward, out of back slots and out of
microwave oven.
4. Wash shield in warm soapy water.
5. Dry and replace.
Important
•
Do not wash in dishwasher.
•
Do not use abrasive cleaners.
Important! Wear gloves to protect hands should
light bulb break. If hot, allow bulb to cool.
To change oven light bulb:
1. Remove access screw from and open access
cover on top left wall of oven exterior.
2. Remove bulb, being careful not to burn fingers
or break bulb.
3. Replace bulb.
4. Replace access cover and replace access
screw. Do not operate oven with access cover
removed.
5. Restore power to microwave oven.
56
Advertisement
Table of Contents
