Table of Contents
Advertisement
Automatic Ice and
Water Dispenser
(continued)
3 . Unscrew filter cup, counterclockwise (Figure 1). If you have trouble unscrewing
cup, use the cup removal wrench included in parts bag (Figure 2).
4. You must replace existing large O-ring on filter housing. First remove old ring and
discard. (You may need to use a toothpick to get under ring. NOTE: Use caution
so that groove that holds ring is not damaged!) Carefully remove new O-
ring from sealed bag. Gently roll O-ring into place, into containment groove
above threads.
5 . Remove packaging from filter cartridge.
6 . Place filter cartridge in cup. The end with the small O-ring should be up, out of
the cup.
7 . Screw cup, with filter, back onto housing. DO NOT USE WRENCH TO REINSTALL
CUP. Filter cartridge will self-align as cup is tightened. Be sure cup is completely
tightened with PureSource™ Logo facing outward. DO NOT TIGHTEN PAST
STOP.
8 . Set ice maker lever to the ON (down) position.
9 . Check for leaks. Open refrigerator door. Wipe any water drops from filter cup.
Run a glass of water. If there is a leak, unscrew filter cup, and reinsert filter
cartridge. Check placement of large O-ring (see directions following). Reinstall
f i l t e r c u p .
10.To condition filter system and purge air from water line, run several glasses
of water through water dispenser. This will also assure the purest water
possible is stored in water tank.
Remember to keep your wrench handy!
Figure 2
Figure 1
Filter Housing
Large O-ring
Small O-ring
Threads
Filter Cartridge
Filter Cup
Advertisement
Table of Contents
