Table of Contents
Advertisement
English
► Pull the hand guard towards the front handle
until there is an audible click and it is in posi‐
tion ‚ – the chain brake is disengaged.
1
► Depress the trigger switch lockout (1) with
your thumb.
► Squeeze the trigger switch (2) with your index
finger.
► Start the cut with the chain running.
The motor runs only if the hand guard is on
‚ and the trigger switch lockout (1) and trigger
switch (2) are operated simultaneously.
16 Switching Off
1
► Release the trigger switch (2) so that it can
return to the off position. It is locked in this
position by the trigger switch lockout (1).
The coasting brake brings the chain to a stand‐
still.
22
2
2
WARNING
The coasting brake operates immediately only if
the trigger switch is fully released. If you release
the trigger switch slowly or only partly, the saw
chain will continue to run for several seconds.
► Move hand guard to ƒ – the chain is locked.
During longer work breaks – disconnect the plug
from the wall outlet.
When the machine is not in use, store it in such a
way that it does not endanger others.
Secure it against unauthorized use.
17 Overload Cutout
The overload cutout interrupts the power supply
to the saw in the case of mechanical overload
due to, e.g.
– excessive feed force
– "lugging down" the motor
– pinching the saw chain in the cut
If the overload cutout has interrupted the power
supply:
► Pull the guide bar out of the cut.
► If necessary, disengage the chain brake – see
"Chain Brake".
This power tool is equipped with an electronic
overload cutout to monitor motor temperature
and power consumption.
16 Switching Off
1
0458-764-0121-B
Advertisement
Table of Contents
