Lighting Area Adjustment - Panasonic PT-AE900U Service Manual

PT-AE900U / PT-AE900E
7.4.3. Adjustment Procedure
Prepare 2 pieces of thick black paper (23 mm × 100 mm) that
can be shaded.
· Cover and shade LCD panels with the paper except the
panel for adjustment.
7.4.3.1. When replacing single LCD panel
(R, G or B)
· The procedure is described as an example when LCD panel
(B) is replaced.
1. Display the green crosshatch pattern and adjust the lens
focus.
2. Display green and blue crosshatch patterns.
3. Adjust focus by shifting the panel adjuster for LCD panel (B)
back and forth, then tighten the 2 screws.
4. Adjust the LCD panel (B) position so that the vertical center
of blue crosshatch pattern is overlapped with the vertical
center of green crosshatch pattern.
5. Adjust the LCD panel (B) position so that the horizontal
center of blue crosshatch pattern is overlapped with the
horizontal center of green crosshatch pattern.
6. Correct the tilt of the blue crosshatch pattern by adjusting
the LCD panel (B) position.
7. Display green, red and blue crosshatch patterns and
confirm the convergence. If it is necessary, fine adjust the
convergence so that the red and/or blue crosshatch pattern
is overlapped with green one.
All manuals and user guides at all-guides.com
Repeat steps (1) to (3) until the green and blue crosshatch
patterns merge into a cyan pattern.
8. After the adjustment, reassemble the projector according to
the section 6.13. "Replacement of LCD Panel".
7.5.
7.5.1.
Service Kit (Part No. TZSH07018): This kit is composed of 3
extension flexible cables and 3 connector extension cables.
Note:
7.5.2.
1. Remove the upper case and the connector cover according
24

Lighting Area Adjustment

Tools to be used
· Consult your dealer or Authorized Service Center for the
service kit.
Preparation