Table of Contents
Advertisement
Before Use
In
on
2.Put down the machine backwards, Remove the four screws (figure 2.)
upright.
Dismantle the transport
The transpo
on bolts are designed for clamping an -
vib
on components inside of the washing machine during
the transpo
on process.
Remove the back cover.
Remove the four bolts on the rear side and take out
Replace the back cover.
Fill the holes le by the bolts with blanking plugs.
Note:
When you replace the back cover, the convex
must face to outside, and you have to insert the
back cover from the two gaps as shown in fig.5.
Keep the transporta on bo
stabilizers in a safe place for later use.
Adjus ng the feet and locking nut
There are adjustable feet under the bo om of the washing machine. Before
use, they should be adjusted so that the machine is level. This will minimize
vibr ons and thus noise during use. It will also reduce wear and tear. We
recommend to use a spirit level for adjustment.Floor should be as stable and
flat as possible.
1. Loose the lock nut (1) by using a wrench.
2. Adjust the high by turning the foot (2).
3. Tighten the lock nut (1) against the housing.
1.
on bolts
6
They are used for
3.
2.
5.
Advertisement
Table of Contents
