Table of Contents
Advertisement
O
perations
3. Replace the dirt container by
pushing it back into the swivel head
until it snaps back into place.
steam cleaning hard floors
Your steam & sweep is designed to
clean hard flooring such as ceramic
tile, vinyl, marble, stone and sealed
hard wood floors. use of your
steam & sweep on waxed or some
unwaxed floors may result in a
diminished glossiness. the steam &
sweep is not for use on unsealed
wood floors. ensure that the steam
& sweep is throughly tested in an
inconspicuous area prior to clean-
ing a large floor area. also be sure
to check the care instructions from
your flooring manufacturer.
1. When the ready light illuminates,
begin cleaning by slowly passing
over the surface while pressing the
steam on demand trigger to emit
steam as needed.
2. To sanitize an area of your floor,
(attack invisible germs and bacteria)
leave the Steam & Sweep over the
area for a minimum of 15 seconds
using continuous steam, but no longer
than 20 seconds. for larger areas,
overlap swivel head placement.
3. When the Steam & Sweep stops
emitting steam, turn the unit off.
Simply remove the water tank, refill,
and continue cleaning.
note: upon first use of this
steam product or first use of
a new filter, the pump may
make a "knocking" sound while
the filter fills with water. this
sound is normal and may last
up to one minute. continue to
depress the trigger until the
knocking sound subsides and
the unit emits steam.
8
w w w . b i s s e l l . c o m
WaRning:
Never put descaling
aromatic, alcoholic, or
detergent products into
the steam cleaner, as this
may damage it or make it
unsafe for use.
Tip:
The Steam & Sweep may be
used as both a steam mop and a
sweeper at the same time.
caution:
Exercise extreme care when
using the Steam&Sweep on
timber flooring. Ensure the
Steam&Sweep is thoroughly
tested in an inconspicuous
area prior to mopping a large
floor area. The Steam&Sweep
generates hot steam, so
when depressing the trigger
to apply steam, ensure the
Steam&Sweep is moving
continuously. The trigger does
not need to be depressed at all
times. Prolonged application
of steam in one area increases
the risk of damage to the
surface treatment on timber
floors. Check with your timber
floor treatment and application
specialist prior to team&Sweep
operation. Regular foot traffic
and direct sunlight will wear
down timber floor surface
treatment, making it more
susceptible to steam damage.
Exercise extreme care when
using the Steam&Sweep on
timber flooring.
Advertisement
Table of Contents
