Husky H61CH6TR12 Use And Care Manual page 3

7. Extension cord
□
Follow all Extension cord manufacturer's Warnings and
Instructions.
□
Do NOT insert extension cord through hole without
grommet in place.
□
Only use a three-wire extension cord with all three prongs
intact. Never remove the round grounding prong.
□
Extension cord must be connected to a 125 Volt GFCI
protected outlet with proper ground. If GFCI outlet is not
available, use an extension cord with GFCI protection
built in.
□
Check the insulation and plugs of extension cord before
using. Do NOT use cord if it is worn or damaged.
□
Do NOT overload extension cord.
□
Remove extension cord from the hole
before moving or transporting storage chest.
□
Only use an extension cord that is rated for outdoor use.
□ Do NOT connect extension cord to outlet that also sup-
plies critical safety equipment with power.
8. Electrical Shock Hazard
□ Do NOT plug cord into outlet with wet hands.
□ Do NOT use this tool chest near a bathtub, a shower, or a
swimming pool.
□ Chest/Cabinet plugs must match the outlet.
□ Never modify the plug in any way.
□ Do NOT use any adapter plugs with earth (grounded) chest
power strips.
□ Unmodified plugs and matching outlets will reduce the risk
of electric shock.
□ Avoid body contact with earthed or grounded surfaces.
There is an increased risk of electric shock if your body is
earthed or grounded.
CAUTION: RISK OF ELECTRICAL SHOCK: This unit has a
power supply cord. Make sure the cord is unplugged
before any servicing or cleaning.
WARNING: Changes or modifications to this unit not
expressly approved by the party responsible for
compliance could void the user's authority to operate
the equipment.
NOTE : This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
NOTE : This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.However, there
is no guarantee that interference will not occur in
a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
□ Reorient or relocate the receiving antenna.
□ Increase the separation between the equipment and
receiver.
□ Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
□ Consult the dealer or an experienced radio/TV
technician for help.
3 Please contact 1-888-HD-HUSKY for further assistance.
HUSKYTOOLS.COM