Maintenance; Accessories - RIDGID 648846056166 Operator's Manual

MAINTENANCE

WARNING:
When servicing use only identical RIDGID
replacement parts. Use of any other parts may
create a hazard or cause product damage.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure to do
so could result in objects being thrown into your
eyes resulting in possible serious injury.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may
result in serious personal injury.
Electric tools used on fiberglass material, wallboard, spack-
ling compounds, or plaster are subject to accelerated wear
and possible premature failure because the fiberglass chips
and grindings are highly abrasive to bearings, brushes,
commutators, etc. Consequently, we do not recommended
using this tool for extended work on these types of materials.
However, if you do work with any of these materials, it is ex-
tremely important to clean the tool using compressed air.

ACCESSORIES

Look for these accessories where you purchased this product:
 Edge Guide Kit ................................................................................................................................................. 201754003
 Anti-Splintering Insert ...................................................................................................................................... 521976001
WARNING:
Current attachments and accessories available for use with this tool are listed above. Do not use any attachments
or accessories not recommended by the manufacturer of this tool. The use of attachments or accessories not
recommended can result in serious personal injury.
Find Quality Products Online at:
LUBRICATION
All of the bearings in this product are lubricated with a suf-
ficient amount of high grade lubricant for the life of the unit
under normal operating conditions. Therefore, no further
lubrication is required.
CHECKING/REPLACING EXTERNAL
BRUSHES
See Figure 16, page 15.
NOTE: The saw is equipped with externally accessible
brushes.
 Unplug the saw.
 Remove brush caps using a screwdriver.
 Remove brush assemblies.
 Check for wear. Replace both brush assemblies when
 Reassemble using new brush assemblies. Make sure
 Reassemble by reversing the steps listed above.
 Tighten all brush caps securely. Do not over tighten.
11 - English
GlobalTestSupply
www.
NOTE: Brush caps are located on each side of the motor
housing.
either has less than 1/4 in. length of carbon remaining.
NOTE: Do not replace one side without replacing the
other.
curvature of brush matches curvature of motor and that
brush moves freely in brush tube.
.com
sales@GlobalTestSupply.com