Pads & Trigger Input Jacks - Yamaha DTX Drums PCY175 Owner's Manual

6
Place one of the felt pads removed in Step 2 on the cymbal holder. (See Figure 5.)
7
Mount the pad unit on the cymbal stand. Lower the pad unit into place with the cymbal holder's
shaft passing through the central hole of the Cup section. When mounted, the stopper's pin should
rest inside the pad unit's smaller hole. (See Figure 5.)
• Playing your pad unit without the stopper's pin positioned fully inside the smaller hole could
cause slip out of the hole. It is very important, therefore, to ensure that the stopper is secured
as shown in Step 5 above.
8
For PCY135, PCY155 and PCY175:
Place one of the felt pads removed in Step 2 on the cymbal holder. (See Figure 5.)
For PCY100:
Place the felt pad that came with your pad unit. The second felt pad removed from the cymbal
holder in Step 2 above is not required for assembly of your pad unit. (See Figure 5.)
9
Tighten the wing nut to secure the pad unit to the cymbal holder. (See Figure 5.)
Felt pad removed in Step 2
(Only for PCY100: The felt
pad that came with pad unit)
Pad unit
Felt pad removed in Step 2
Bolt cover
Cymbal holder
Pads & Trigger Input Jacks
The function of the PCY series pads varies according to which trigger input jack on the DTX Series
Drum Trigger Module the pad is connected.
Refer to owner's manual included with the drum trigger module and/or to the page for your specific
product on the Yamaha website for information on the functions relevant to trigger input jacks.
Wing nut
Cup
Pin
Stopper
[Figure 5]
12
Stopper's pin
Cup
Pad unit
Smaller
hole