Table of Contents
Advertisement
Available languages
Available languages
Custom under-counter installation:
(686 mm)
1"
(25 mm)
Recessed area or closet installation:
3"
(76 mm)
48 in.
2
(310 cm
)
2
24 in.
2
3"
(155 cm
)
2
(76 mm)
(5 mm)
Custom cabinet installation:
0.25"
1"
(5 mm)
(25 mm)
16
39" min.
(990 mm)
1"
27"
(25 mm)
1"
(25 mm)
0.25"
1"
1"
(25 mm)
(25 mm)
1"
(25 mm)
1"
1"
(25 mm)
(25 mm)
DRAIN SYSTEM
The drain system can be installed using a floor drain, wall
standpipe, floor standpipe, or laundry tub. Select the method
you need.
IMPORTANT:
hose should be inside standpipe. Always secure drain hose with
cable tie.
Floor standpipe drain system
4.5"
(114 mm)
Minimum diameter for a standpipe drain: 2" (51 mm). Minimum
carry-away capacity: 17 gal. (64 L) per minute. A 1/4" (6 mm)
diameter to 1" (25 mm) diameter Standpipe Adapter Kit is
available (Part Number 3363920). Top of standpipe must be at
least 30" (762 mm) high; install no higher than 96" (2.44 m) from
bottom of washer. If you have an overhead sewer and need to
pump higher than 96" (2.44 m), a sump pump and associated
hardware are needed. See "Alternate parts."
Wall standpipe drain system
4.5"
(114 mm)
1"
(25 mm)
See requirements for floor standpipe drain system.
Laundry tub drain system
4.5"
(114 mm)
Minimum capacity: 20 gal. (76 L). Top of laundry tub must
be at least 30" (762 mm) above floor; install no higher than
96" (2.44 m) from bottom of washer.
To avoid siphoning, only 4.5" (114 mm) of drain
min.
30"
(762 mm)
Advertisement
Table of Contents
