Lenovo ThinkSystem SR950 Setup Manual page 317

Figure 81. System board filler removal
Step 1. Press the release clips and slide the system board filler out of the compute tray.
After you remove the system board filler:
• If you are instructed to return the system board filler, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.
• If you are planning to recycle the system board filler, follow the instructions in "Disassemble the system
board filler for recycle" in Maintenance Manual for compliance with local regulations.
Install a system board filler
Install a system board filler by inserting it in the compute tray and pushing it in until it locks in place.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
"
CAUTION:
Make sure that all server power cords are disconnected from their power sources before performing
this procedure.
Complete the following steps to install the compute system board filler:
Watch the procedure. A video of the replacement process is available:
" on page 56 " " on page 254
Appendix B. Component reference
313