Settings
Electrical version
You can set the voltage variant. The
setting must correspond to the voltage
of your domestic electrical supply.
Probe
The oven is factory set to automatically
detect the probe.
If you have purchased a new Miele
probe, you must enter a 12-digit code
for this setting. You can then start using
the probe.
Follow the description supplied with
the replacement part.
Software version
The software version menu option is for
use by Miele Technical Service. You do
not need this information for domestic
use.
Confirm with OK.
Legal information
You can find an overview of the
integrated open-source components
under
Open Source Licenses
Confirm with OK.
Showroom Program
This function enables the oven to be
demonstrated in showrooms without
heating up. Do not activate this setting
for domestic use.
Demo Mode
If you have Demo mode activated,
Demo mode is active. The appliance will
will appear when you turn
not heat up
on the oven.
64
-
-
Factory default
-
-
-
-
Lift-up panel
.
-
-
On
Touch OK for at least 4 seconds to
activate Demo mode.
Off
Touch OK for at least 4 seconds to
deactivate Demo mode. You can use
the oven as normal.
Appliance settings
Any settings that have been altered
will be reset to the factory default
settings.
Favorites
All Favorites will be deleted.
MyMiele
All MyMiele entries will be deleted.
Recommended temperatures
Any recommended temperatures that
have been changed will be reset to
the factory default settings.
Regardless of the setting selected, as
soon as you start the Self Clean
program the lift panel will go down
automatically.
Automatic
The lift panel raises automatically as
soon as you turn the range on.
The lift panel goes down
automatically as soon as you turn the
range off.
Manual
Touch the Lift Panel sensor button to
raise and lower the lift panel.