Pre-Maintenance Procedures; Releasing The Mower-Deck Curtain; Removing The Sheet-Metal Guard - Toro 2000 Series Operator's Manual

Maintenance Service
Interval
Every 500 hours
Monthly
Yearly or before storage
Important:
Refer to your engine owner's manual for additional maintenance procedures.
CAUTION
If you leave the key in the switch, someone could accidently start the engine and seriously
injure you or other bystanders.
Shut off the engine and remove the key from the switch before you perform any maintenance.
Pre-Maintenance
Procedures
Releasing the Mower-Deck
Curtain
Loosen the top bolt of the curtain to release the
mower-deck curtain and access the top of the mower
deck (Figure 37). Tighten the bolt after maintenance
to install the curtain.
Figure 37
1. Bolt
Maintenance Procedure
• Replace the safety air filter (more often in dirty or dusty conditions).
• Replace the emissions-air intake filter.
• Replace the fuel filter (more often in dusty, dirty conditions).
• Check the parking brake adjustment.
• After the initial change—change the hydraulic-system filters and fluid when using
Toro® HYPR-OIL™ 500 fluid. (Change it more often under dirty or dusty conditions)
• Check the battery charge.
• Paint chipped surfaces.
• Check all maintenance procedures listed above before storage.
g193016
2. Curtain
Removing the Sheet-Metal
Guard
Loosen the 4 bolts and remove the sheet-metal guard
to access the mower belts and spindles
After performing maintenance, install the sheet-metal
guard and tighten the bolts.
1. Sheet-metal guard
34
(Figure
Figure 38
2. Bolt
38).
g192921